Last Modified: 04-05-2023 6.11:8.1.0 Doc ID: RM1000000018QYQ
Model Year Start: 2018 Model: Sienna Prod Date Range: [11/2017 -           ]
Title: NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: B153A; GVIF Disconnected (from Extension Module to H/U); 2018 - 2020 MY Sienna [11/2017 -        ]

DTC

B153A

GVIF Disconnected (from Extension Module to H/U)

DESCRIPTION

DTC Code

DTC Detection Condition

Trouble Area

B153A

GVIF disconnected (from navigation ECU to radio and display receiver assembly)

  • No. 1 navigation wire
  • Navigation ECU
  • Radio and display receiver assembly

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:

  • A communication malfunction DTC is stored.
  • The radio and display receiver assembly may not operate normally.

PROCEDURE

1.

CHECK DTC

(a) Clear the DTCs.

(b) Recheck for DTCs and check that no DTCs are output.

OK:

No DTCs are output.

OK

USE SIMULATION METHOD TO CHECK

NG

2.

CHECK NAVIGATION WIRE (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION ECU)

(a) Disconnect the V14 navigation ECU connector.

*a

Front view of wire harness connector

(to Radio and Display Receiver Assembly)

*b

Front view of wire harness connector

(to Navigation ECU)

(b) Disconnect the V13 radio and display receiver assembly connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

V14-1 (GVO-) - V13-1 (GV2-)

Always

Below 1 Ω

V14-2 (GVO+) - V13-2 (GV2+)

Always

Below 1 Ω

V14-3 (GVG1) - V13-3 (GVG2)

Always

Below 1 Ω

NG

REPLACE NAVIGATION WIRE

OK

3.

REPLACE NAVIGATION ECU

(a) Replace the navigation ECU with a new one.

Click here 2018 - 2020 MY Sienna [11/2017 -        ]; NAVIGATION / MULTI INFO DISPLAY: NAVIGATION ECU: REMOVAL

NEXT

4.

CHECK DTC

(a) Clear the DTCs.

(b) Recheck for DTCs and check that no DTCs are output.

OK:

No DTCs are output.

OK

END (NAVIGATION ECU WAS DEFECTIVE)

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY