Last Modified: 04-05-2023 6.11:8.1.0 Doc ID: RM1000000018JBR
Model Year Start: 2018 Model: Sienna Prod Date Range: [11/2017 -           ]
Title: PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: DATA LIST / ACTIVE TEST; 2018 - 2020 MY Sienna [11/2017 -        ]

DATA LIST / ACTIVE TEST

DATA LIST

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Chassis / Advanced Parking Guidance/Parking Assist Monitor / Data List.

(e) Read the Data List according to the display on the Techstream.

Advanced Parking Guidance/Parking Assist Monitor

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Video Output Status

Output condition of video signal

OK or NG

OK: Output condition of video signal is normal

NG: Output condition of video signal is abnormal

-

Destination Data Check

Verification of destination data

OK or NG

OK: Data verification normal

NG: Data verification abnormal

-

RHD/LHD Signal Check

Verification of RHD/LHD signal

OK or NG

OK: Output condition of RHD/LHD signal is normal

NG: Output condition of RHD/LHD signal is abnormal

-

Circumference Monitoring System Type Check

Verification of rear television camera assembly signal

OK or NG

OK: Rear television camera assembly normal

NG: Rear television camera assembly abnormal

-

EEPROM Status (Initial read)

Rear television camera assembly information

OK or NG

OK: Rear television camera assembly normal

NG: Rear television camera assembly abnormal

-

CPU Communication Status

Rear television camera assembly information

OK or NG

OK: Rear television camera assembly normal

NG: Rear television camera assembly abnormal

-

Number of DTC

Number of stored DTCs

min.: 0, max.: 255

Number of DTCs will be displayed

-

Current Key Cycle

Cumulative number of times the engine switch was turned on (IG)

Min.: 0, Max.: 65535 time

Cumulative number of times the engine switch was turned on (IG) will be displayed

-

Current Key Cycle Elapsed Time

Time elapsed since the engine switch was turned on (IG)

Min.: 0, Max.: 1677721.5 s

Time elapsed since the engine switch was turned on (IG) will be displayed

-