Last Modified: 04-05-2023 6.11:8.1.0 Doc ID: RM1000000018JAU
Model Year Start: 2018 Model: Sienna Prod Date Range: [11/2017 -           ]
Title: PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: C1621; Back Camera Power Supply Failure; 2018 - 2020 MY Sienna [11/2017 -        ]

DTC

C1621

Back Camera Power Supply Failure

DESCRIPTION

This DTC is stored if the rear television camera assembly judges as a result of its self check that the signals or signal lines between the rear television camera assembly and radio and display assembly are not normal.

DTC Code

DTC Detection Condition

Trouble Area

C1621

Rear television camera assembly power supply failure

  • Harness or connector
  • Rear television camera assembly
  • Radio and display receiver assembly

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

    Click here 2018 - 2020 MY Sienna [11/2017 -        ]; PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: CALIBRATION

  • When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occurs:
    • A communication malfunction DTC may be stored.
    • The radio and display receiver assembly may not operate normally.

PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)

(a) Disconnect the D196 radio and display receiver assembly connector.

(b) Disconnect the W30 rear television camera assembly connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

D196-30 (CA+) - W30-6 (CB+)

Always

Below 1 Ω

D196-27 (CGND) - W30-5 (CGND)

Always

Below 1 Ω

D196-30 (CA+) or W30-6 (CB+) - Body ground

Always

10 kΩ or higher

D196-27 (CGND) or W30-5 (CGND) - Body ground

Always

10 kΩ or higher

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

2.

INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY

(a) Reconnect the radio and display receiver assembly connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

D196-27 (CGND) - Body ground

Always

Below 1 Ω

*a

Component with harness connected

(Radio and Display Receiver Assembly)

(c) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Condition

Specified Condition

D196-30 (CA+) - D196-27 (CGND)

Engine switch on (ACC)

5.5 to 7.05 V

OK

REPLACE REAR TELEVISION CAMERA ASSEMBLY

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY