Last Modified: 04-05-2023 |
6.11:8.1.0 |
Doc ID: RM1000000018JAI |
Model Year Start: 2018 |
Model: Sienna |
Prod Date Range: [11/2017 -
] |
Title: PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: HOW TO PROCEED WITH TROUBLESHOOTING; 2018 - 2020 MY Sienna [11/2017 - ] |
HOW TO PROCEED WITH TROUBLESHOOTING
|
CAUTION / NOTICE / HINT
HINT:
-
Use the following procedure to troubleshoot the parking assist monitor system.
-
*: Use the Techstream.
PROCEDURE
1.
|
VEHICLE BROUGHT TO WORKSHOP
|
NEXT
|
|
|
2.
|
CUSTOMER PROBLEM ANALYSIS
|
(a) Ask the customer about the problems and the conditions at the time the malfunction occurred to make sure the problem symptom was not temporarily caused by radio waves in the surrounding environment.
HINT:
The parking assist monitor display may be temporarily distorted due to radio waves around the vehicle.
Problem Symptom
|
Cause
|
The following condition is met:
The problem symptom indicates a parking assist monitor display malfunction and the problem symptom cannot be reproduced.
|
The display may be temporarily distorted when the vehicle is close to an object that transmits radio waves, such as a telecommunication tower, an airport or a truck equipped with a transceiver.
|
NEXT
|
|
|
3.
|
INSPECT BATTERY VOLTAGE
|
(a) Measure the battery voltage.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.
NEXT
|
|
|
4.
|
CHECK NAVIGATION SYSTEM
|
(a) Refer to Navigation System.
Click here
Result
|
Proceed to
|
Navigation system is normal
|
A
|
Navigation system is abnormal
|
B
|
A
|
|
|
5.
|
CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
|
(a) Use the Techstream to check if the CAN communication system is functioning normally.
Click here
Result
|
Proceed to
|
CAN communication system DTCs are not output
|
A
|
CAN communication system DTCs are output
|
B
|
A
|
|
|
(a) Check for DTCs and make a note of any codes that are output.
Click here
(b) Clear the DTCs.
Click here
(c) Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.
Click here
Result
|
Proceed to
|
No DTCs are output
|
A
|
DTCs are output
|
B
|
A
|
|
|
7.
|
PROBLEM SYMPTOMS TABLE
|
(a) Refer to Problem Symptoms Table.
Click here
Result
|
Proceed to
|
Fault is not listed in Problem Symptoms Table
|
A
|
Fault is listed in Problem Symptoms Table
|
B
|
A
|
|
|
8.
|
OVERALL ANALYSIS AND TROUBLESHOOTING
|
(a) Diagnosis System
Click here
(b) Terminals of ECU
Click here
(c) Data List / Active Test
Click here
NEXT
|
|
|
9.
|
ADJUST, REPAIR OR REPLACE
|
NEXT
|
|
|
NEXT |
|
END
|
|