| Last Modified: 04-05-2023 | 6.11:8.1.0 | Doc ID: RM1000000018J5B |
| Model Year Start: 2018 | Model: Sienna | Prod Date Range: [11/2017 - ] |
| Title: PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: C1697; Camera Position Adjustment Incomplete; 2018 - 2020 MY Sienna [11/2017 - ] | ||
|
DTC |
C1697 |
Camera Position Adjustment Incomplete |
DESCRIPTION
This DTC is stored when the parking assist ECU judges that the camera initial setting has not been memorized (camera view adjustment is incomplete).
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
C1697 |
Camera Position Adjustment Incomplete |
Camera initial setting has not been memorized |
|
CAUTION / NOTICE / HINT
NOTICE:
-
When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.
Click here
![2018 - 2020 MY Sienna [11/2017 - ]; PARK ASSIST / MONITORING: PANORAMIC VIEW MONITOR SYSTEM: INITIALIZATION](/t3Portal/stylegraphics/info.gif)
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click here
PROCEDURE
|
1. |
ADJUST SETTINGS (CAMERA VIEW ADJUSTMENT) |
(a) Perform the following procedure depending on the memory conditions to register the vehicle information to the parking assist ECU.
(1) Refer to camera view adjustment.
Click here
|
|
2. |
CHECK FOR DTC |
(a) Clear the DTCs.
Click here
(b) Check for DTCs.
Click here
OK:
DTC C1697 is not output.
HINT:
- If DTC C1697 is output, perform the camera view adjustment again.
- If DTC C1697 is still output after performing the camera view adjustment 3 times, replace the parking assist ECU.
| OK |
|
END (CAMERA VIEW ADJUSTMENT IS DEFECTIVE) |
| NG |
|
|
|