Last Modified: 04-05-2023 |
6.11:8.1.0 |
Doc ID: RM1000000018IMG |
Model Year Start: 2018 |
Model: Sienna |
Prod Date Range: [11/2017 -
] |
Title: CRUISE CONTROL: FRONT CAMERA: REMOVAL; 2018 - 2020 MY Sienna [11/2017 - ] |
REMOVAL
CAUTION / NOTICE / HINT
NOTICE:
-
When replacing the forward recognition camera, replace it with a new one.
-
Do not touch the camera lens or the front windshield glass in front of the camera.
-
If the forward recognition camera has been struck or dropped, replace it with a new one.
-
When replacing the windshield glass of a vehicle equipped with a forward recognition camera, make sure to use a Toyota genuine part. If a non-Toyota genuine part is used, the forward recognition camera may not be able to be installed due to a missing bracket. Also, the dynamic radar cruise control system, forward recognition camera system, lane departure alert system, pre-collision system may not operate properly due to a difference in the transmissivity or black ceramic border.
-
Do not touch the internal components of the forward recognition with heater hood sub-assembly or press on the heater when working on the forward recognition with heater hood sub-assembly.
PROCEDURE
1. REMOVE NO. 2 FORWARD RECOGNITION COVER
(a) Disengage the 2 claws and 2 guides to remove the No. 2 forward recognition cover as shown in the illustration.
|
Remove in this Direction (1)
|
|
Remove in this Direction (2)
|
NOTICE:
If these claws are disengaged separately, they may break. Insert a molding remover between them and pull it down to disengage the claws simultaneously.
2. REMOVE NO. 1 FORWARD RECOGNITION COVER
(a) Disengage the 2 clips and 2 guides to remove the No. 1 forward recognition cover as shown in the illustration.
|
Remove in this Direction
|
NOTICE:
To avoid damaging the guides, always slide the No. 1 forward recognition cover parallel to the windshield glass.
3. REMOVE FORWARD RECOGNITION LATCH
(a) Disengage the 2 claws in the direction indicated by the arrow (1) in the illustration.
|
Remove in this Direction (1)
|
|
Remove in this Direction (2)
|
(b) Disengage the 4 guides in the direction indicated by the arrow (2) in the illustration to remove the forward recognition latch.
4. REMOVE FORWARD RECOGNITION CAMERA
(a) Disconnect the connector.
|
Remove in this Direction
|
(b) Disengage the 4 guides to remove the forward recognition camera as shown in the illustration.
NOTICE:
-
Do not pull the harness forcibly when disconnecting the connector.
-
If the forward recognition camera bracket is deformed or damaged, replace it together with the windshield glass.
-
If the forward recognition camera has been struck or dropped, replace it with a new one.
-
Do not apply excessive force.
|