INSTALLATION

CAUTION / NOTICE / HINT

NOTICE:

If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.

PROCEDURE

1. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY

NOTICE:

If the front bumper assembly, radiator grill, millimeter wave radar sensor assembly or No. 1 millimeter wave radar sensor bracket has been replaced, check that the beam axis change mechanism is at the standard position (centered).

(a) Set beam axis to the standard position. (1) Turn the bolt so that the beam axis change mechanism is positioned as shown in the illustration. Specified Condition: Difference between (A) and (B) 1 mm (0.0394 in.) or less Torque: 1.5 N·m {15 kgf·cm, 13 in·lbf}

(b) Engage the 2 guides to install the millimeter wave radar sensor assembly.

	Bolt
	Screw

(c) Install the 2 bolts and 2 screws in the order shown in the illustration.

Torque:

Bolt :

2.5 N·m {25 kgf·cm, 22 in·lbf}

(d) Connect the connector.

2. ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY

Click here

3. INSTALL RADIATOR GRILLE SUB-ASSEMBLY

Click here