AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: B158F; AV Signal Stoppage (Low Battery Voltage); 2018 - 2020 MY Sienna [11/2017

Last Modified: 04-05-2023	6.11:8.1.0	Doc ID: RM1000000018F7M
Model Year Start: 2018	Model: Sienna	Prod Date Range: [11/2017 - ]
Title: AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: B158F; AV Signal Stoppage (Low Battery Voltage); 2018 - 2020 MY Sienna [11/2017 - ]

DTC

B158F

AV Signal Stoppage (Low Battery Voltage)

DESCRIPTION

This DTC is stored when a video or audio signal is interrupted due to battery voltage input to the radio and display receiver assembly dropping temporarily.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area
B158F	AV Signal Stoppage (Low Battery Voltage)	A video or audio signal is interrupted when the battery voltage drops	Radio and display receiver assembly Harness or connector

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occurs:
- A communication malfunction DTC may be stored.
- The radio and display receiver assembly may not operate normally.
Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE

1.	CHECK VEHICLE SIGNAL (OPERATION CHECK)

(a) Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Vehicle Signal in Operation Check (See page )]

(b) Check that the battery voltage.

Standard voltage:

11 to 14 V

HINT:

This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.

GO TO STEP 3

2.	CHECK FOR DTC

(a) Clear the DTCs (See page ).

(b) Check for DTCs (See page ).

OK:

No DTCs are output.

USE SIMULATION METHOD TO CHECK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

3.	CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY POWER SOURCE)

(a) Disconnect the radio and display receiver assembly connector.

*a	Front view of wire harness connector (to Radio and Display Receiver Assembly)

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection	Condition	Specified Condition
D195-4 (+B1) - Body ground	Always	11 to 14 V

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

REPAIR OR REPLACE HARNESS OR CONNECTOR