Last Modified: 04-05-2023 6.11:8.1.0 Doc ID: RM1000000018F7K
Model Year Start: 2018 Model: Sienna Prod Date Range: [11/2017 -           ]
Title: AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: B1585; USB Device Malfunction; 2018 - 2020 MY Sienna [11/2017 -        ]

DTC

B1585

USB Device Malfunction

DESCRIPTION

This DTC is stored when a malfunction occurs in a connected device.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

B1585

USB Device Malfunction

When any of the following conditions is met:

  • A non mass-storage class or incompatible protocol USB device connected
  • USB device with an incompatible file system, corrupted or incompatible File Allocation Table (FAT) connected
  • "iPod" malfunction
  • "iPod" with unsupported firmware connected
  • Unsupported "iPod" model connected
  • USB device or "iPod"
  • Radio and display receiver assembly

CAUTION / NOTICE / HINT

NOTICE:

  • Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

    Click here 2018 - 2020 MY Sienna [11/2017 -        ]; AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: PRECAUTION

  • When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occurs:
    • A communication malfunction DTC may be stored.
    • The radio and display receiver assembly may not operate normally.

PROCEDURE

1.

REPLACE USB DEVICE OR "iPod"

(a) Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

(b) Turn the ignition switch off.

HINT:

When this DTC has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

(c) Turn the ignition switch to ACC.

(d) Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

HINT:

  • If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
  • Refer to System Description for compatible formats and versions (See page 2018 MY Sienna [11/2017 - 08/2018]; AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: SYSTEM DESCRIPTION 2019 - 2020 MY Sienna [08/2018 -        ]; AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: SYSTEM DESCRIPTION ).
NEXT

2.

CHECK FOR DTC

(a) Clear the DTCs (See page 2018 - 2020 MY Sienna [11/2017 -        ]; AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: DTC CHECK / CLEAR ).

(b) Check for DTCs (See page 2018 - 2020 MY Sienna [11/2017 -        ]; AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: DTC CHECK / CLEAR ).

OK:

No DTCs are output.

OK

USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USB DEVICE OR "iPod" WAS DEFECTIVE

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY