- A non mass-storage class or incompatible protocol USB device connected
- USB device with an incompatible file system, corrupted or incompatible File Allocation Table (FAT) connected
- "iPod" malfunction
- "iPod" with unsupported firmware connected
- Unsupported "iPod" model connected
| Last Modified: 04-05-2023 | 6.11:8.1.0 | Doc ID: RM1000000018F7K |
| Model Year Start: 2018 | Model: Sienna | Prod Date Range: [11/2017 - ] |
| Title: AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: B1585; USB Device Malfunction; 2018 - 2020 MY Sienna [11/2017 - ] | ||
|
DTC |
B1585 |
USB Device Malfunction |
DESCRIPTION
This DTC is stored when a malfunction occurs in a connected device.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
B1585 |
USB Device Malfunction |
When any of the following conditions is met: |
|
CAUTION / NOTICE / HINT
NOTICE:
-
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
![2018 - 2020 MY Sienna [11/2017 - ]; AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: PRECAUTION](/t3Portal/stylegraphics/info.gif)
-
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occurs:
- A communication malfunction DTC may be stored.
- The radio and display receiver assembly may not operate normally.
PROCEDURE
|
1. |
REPLACE USB DEVICE OR "iPod" |
(a) Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
(b) Turn the ignition switch off.
HINT:
When this DTC has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.
(c) Turn the ignition switch to ACC.
(d) Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.
HINT:
- If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
-
Refer to System Description for compatible formats and versions (See page
).
|
|
2. |
CHECK FOR DTC |
(a) Clear the DTCs (See page
).
(b) Check for DTCs (See page
).
OK:
No DTCs are output.
| OK |
|
USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USB DEVICE OR "iPod" WAS DEFECTIVE |
| NG |
|
|
|