Last Modified: 04-05-2023 |
6.11:8.1.0 |
Doc ID: RM1000000018DS6 |
Model Year Start: 2018 |
Model: Sienna |
Prod Date Range: [11/2017 -
] |
Title: DOOR / HATCH: HOOD LOCK CONTROL CABLE ASSEMBLY: REMOVAL; 2018 - 2020 MY Sienna [11/2017 - ] |
REMOVAL
PROCEDURE
1. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH
(a) Remove the 4 screws and the front wheel opening extension pad LH.
|
|
2. SEPARATE FRONT FENDER LINER LH
(a) Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
|
|
(c) Remove the 2 screws.
3. REMOVE RADIATOR GRILLE SUB-ASSEMBLY
Click here
4. REMOVE HOOD LOCK NUT CAP
(a) Using a screwdriver with its tip wrapped in protective tape, remove the hood lock nut cap.
Text in Illustration
|
|
5. REMOVE HOOD LOCK ASSEMBLY
(a) Disconnect the connector.
|
|
(b) Remove the 3 bolts and hood lock.
(c) Disconnect the hood lock control cable.
6. REMOVE FRONT DOOR SCUFF PLATE LH
HINT:
Use the same procedure as for the RH side.
Click here
7. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
8. REMOVE COWL SIDE TRIM BOARD LH
HINT:
Use the same procedure as for the RH side.
Click here
9. REMOVE NO. 1 INSTRUMENT PANEL LOWER FINISH PANEL
Click here
10. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY
(a) Disconnect the hood lock control cable from hood lock control lever.
(b) Using a screwdriver with its tip wrapped in protective tape, disconnect the clamps shown in the illustration.
Text in Illustration
*1
|
Hood Lock Control Cable
|
-
|
-
|
(c) Pull the cable from the engine room and remove it.
|