Last Modified: 04-05-2023 |
6.11:8.1.0 |
Doc ID: RM1000000018CXJ |
Model Year Start: 2018 |
Model: Sienna |
Prod Date Range: [11/2017 -
] |
Title: DOOR LOCK: FRONT DOOR LOCK: REMOVAL; 2018 - 2020 MY Sienna [11/2017 - ] |
REMOVAL
CAUTION / NOTICE / HINT
HINT:
-
Use the same procedure for both the RH and LH sides.
-
The procedure described below is for the RH side.
PROCEDURE
1. REMOVE FRONT DOOR ARMREST BASE PANEL ASSEMBLY
Click here
2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
Click here
3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
Click here
4. REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION
Click here
5. REMOVE COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)
Click here
6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
Click here
7. REMOVE OUTER MIRROR CONTROL ECU ASSEMBLY (w/ Memory)
Click here
8. REMOVE FRONT DOOR SERVICE HOLE COVER
Click here
9. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY
HINT:
Use the same procedure as for the LH side.
Click here
10. REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY
HINT:
Use the same procedure as for the LH side.
Click here
11. REMOVE FRONT DOOR CHECK ASSEMBLY
Click here
12. REMOVE FRONT DOOR WEATHERSTRIP
Click here
13. REMOVE FRONT DOOR GLASS RUN
Click here
14. REMOVE FRONT DOOR FRONT LOWER FRAME SUB-ASSEMBLY
Click here
15. REMOVE FRONT DOOR PANEL PROTECTOR
Click here
16. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
Click here
17. REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY
Click here
18. REMOVE FRONT DOOR OUTSIDE HANDLE COVER (for Driver Side)
Click here
19. REMOVE FRONT DOOR LOCK ASSEMBLY
(a) Disconnect the connector.
|
|
(b) Using a T30 "TORX" socket wrench, remove the 3 screws.
(c) Disconnect the front door lock open rod to remove the front door lock assembly as shown in the illustration.
Text in Illustration
*1
|
Front Door Lock Open Rod
|
|
|
(d) When reusing the front door lock assembly:
(1) Remove the door lock wire harness seal from the front door lock.
|
|
20. REMOVE FRONT DOOR LOCK COVER SUB-ASSEMBLY
(a) Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws to open the front door lock cover sub-assembly.
Text in Illustration
|
|
(b) Disengage the 2 guides to remove the front door lock cover sub-assembly.
|
|
21. REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE
(a) Disengage the guide to remove the front door lock remote control cable.
|
|
22. REMOVE FRONT DOOR INSIDE LOCKING CABLE
(a) Disengage the guide to remove the front door inside locking cable.
|
|
|