Last Modified: 04-05-2023 |
6.11:8.1.0 |
Doc ID: RM1000000018CTW |
Model Year Start: 2018 |
Model: Sienna |
Prod Date Range: [11/2017 -
] |
Title: THEFT DETERRENT / KEYLESS ENTRY: CERTIFICATION ECU: INSTALLATION; 2018 - 2020 MY Sienna [11/2017 - ] |
INSTALLATION
PROCEDURE
1. INSTALL CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
(a) Engage the 2 claws to install the certification ECU (smart key ECU assembly).
|
|
2. INSTALL ECU INTEGRATION BOX RH
(a) Install the ECU integration box RH with the 2 nuts and bolt.
(b) Engage the 2 clamps.
HINT:
If the vehicle is equipped with a wire harness clamp, engage the clamp.
(c) Connect each connector.
3. INSTALL MAYDAY ECU ASSEMBLY (w/ Mayday System)
Click here
4. INSTALL PARKING ASSIST ECU (w/ Panoramic View Monitor System)
Click here
5. INSTALL GLOVE COMPARTMENT DOOR SUB-ASSEMBLY
(See page
)
6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH
7. INSTALL COWL SIDE TRIM BOARD RH
(See page
)
8. INSTALL FRONT DOOR SCUFF PLATE RH
(See page
)
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page
).
10. REGISTER KEY
NOTICE:
When replacing the certification ECU (smart key ECU assembly), perform registration (See page
).
11. REGISTER ECU COMMUNICATION ID
NOTICE:
When replacing the certification ECU (smart key ECU assembly), perform registration (See page
).
|