UA80F (AUTOMATIC TRANSMISSION / TRANSAXLE): AUTOMATIC TRANSAXLE SYSTEM: ROAD TEST; 2018 - 2020 MY Sienna [11/2017

(a) Based on the result of the customer problem analysis, try to reproduce the symptoms. If the problem is that the transaxle does not shift up, shift down, or the shift point is too high or too low, conduct the following road test referring to the automatic shift schedule and simulate the problem symptoms.

Strictly observe posted speed limits, traffic laws and road conditions when performing the road test.

NOTICE:

Be sure to inspect and adjust the engine before performing these tests.
Perform the road test with the engine coolant temperature between 60 and 100°C (140 and 212°F) and the ATF temperature between 50 and 100°C (122 and 212°F).

Perform these tests with the air conditioning and cruise control off.

Inspection	Procedure
Transmission Control Switch Test	With the vehicle stationary and the shift lever in D, move the shift lever to S and return it to D. Check that the meter display changes from D to the appropriate S gear and then back again.
S Position Test	While driving with the shift lever in S, move the shift lever to "+" and "-". Check that the meter display changes accordingly.
D Position Shift Test	While driving the vehicle normally, check that the transaxle shifts up and down through each gear properly.
Lock-up Function	While driving on a level surface at a constant speed in the lock-up range with the shift lever in D, lightly depress the accelerator pedal and check that the engine speed does not change abruptly.
P Position Test	Stop the vehicle on an incline (approximately 5° or more). Then move the shift lever to P and release the parking brake. Check that the parking lock pawl holds the vehicle in place.
Abnormal Noise and Vibration	Check for abnormal noise and vibration while driving the vehicle forward and backward, and during shift operations.
Fluid Leakage	After performing all other road test inspections, check for fluid leakage.