Last Modified: 04-05-2023 6.11:8.1.0 Doc ID: RM1000000018AV3
Model Year Start: 2018 Model: Sienna Prod Date Range: [11/2017 -           ]
Title: METER / GAUGE / DISPLAY: METER / GAUGE SYSTEM: DATA LIST / ACTIVE TEST; 2018 - 2020 MY Sienna [11/2017 -        ]

DATA LIST / ACTIVE TEST

1. DATA LIST

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

(a) Warm up the engine.

(b) Turn the ignition switch off.

(c) Connect the Techstream to the DLC3.

(d) Turn the ignition switch to ON.

(e) Turn the Techstream on.

(f) Enter the following menus: Body Electrical / Combination Meter / Data List.

(g) According to the display on the Techstream, read the Data List.

Combination Meter

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

ODO/TRIP Change SW

ODO/TRIP switch

OFF or ON

OFF: Switch released

-

ON: Switch pushed

-

Vehicle Speed Meter

Vehicle speed

Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)

Approximately same as actual vehicle speed (When vehicle is being driven)

-

Engine Rpm

Engine speed

Min.: 0 rpm, Max.: 12750 rpm

600 to 700 rpm: Idling

-

Coolant Temperature

Engine coolant temperature

Min.: 0°C (32°F), Max.: 127.5°C (261.5°F)

80 to 100°C (176 to 212°F): After warming up

-

Washer Switch

Washer level warning switch

OFF or ON

OFF: Washer level warning switch off

-

ON: Washer level warning switch on

Oil Level SW

Engine oil level sensor

OFF or ON

OFF: Engine oil level sensor OFF

-

ON: Engine oil level sensor ON

Check Engine SW

MIL

OFF or ON

OFF: MIL off

-

ON: MIL on

Light Control Switch

Light control switch knob

OFF or ON

OFF: Switch released

-

ON: Switch pushed

Multi Display Select Switch

Steering pad switch (DISP)

OFF or ON

OFF: Switch released

-

ON: Switch pushed

+B Voltage Value

Battery voltage

Min.: 0 V, Max.: 25.5 V

11 to 14 V

-

Integrated value for Maintenance*1

Maintenance required reminder value

Min.: 0, Max.: 25500 (mile)

Driving distance after performing maintenance required reminder reset procedure displayed

If the value is 5000 (miles) or more, perform the maintenance required reminder reset procedure after performing maintenance.

Fuel Input

Fuel input signal

Min.: 0, Max.: 127.5

Current fuel level displayed

Unit: Liter

Ambient Temperature

Outside temperature

Min.: -40°C (-40°F), Max.: 87.5°C (189.5°F)

Almost the same as actual outside temperature

The temperature displayed on the multi-information display is -40 to 50°C (-40 to 122°F).

TPMS Operation State

Condition of tire pressure warning system

OFF, ON or Unknown

OFF: Tire pressure warning system not operating

-

ON: Tire pressure warning system operating

Unknown: Wire harness between combination meter assembly and tire pressure warning ECU open

Multi Switch (Up)

Drive monitor switch (Up)

OFF or ON

OFF: Switch released

-

ON: Switch pushed

Multi Switch (Down)

Drive monitor switch (Down)

OFF or ON

OFF: Switch released

-

ON: Switch pushed

Multi Switch (Menu)

Steering pad switch (Menu)

OFF or ON

OFF: Switch released

-

ON: Switch pushed

Multi Switch (Enter)

Steering pad switch (Enter)

OFF or ON

OFF: Switch released

-

ON: Switch pushed

Multi Switch (Right)

Steering pad switch (Right)

OFF or ON

OFF: Switch released

-

ON: Switch pushed

Multi Switch (Left)

Steering pad switch (Left)

OFF or ON

OFF: Switch released

-

ON: Switch pushed

Oil Pressure Switch

Engine oil pressure switch

OFF or ON

OFF: Engine oil pressure low

-

ON: Engine oil pressure except above

Turn Signal Switch (Right)

RH turn signal switch

OFF or ON

OFF: RH turn signal switch off

-

ON: RH turn signal switch on

Turn Signal Switch (Left)

LH turn signal switch

OFF or ON

OFF: LH turn signal switch off

-

ON: LH turn signal switch on

Hazard Flasher Switch

Hazard warning signal switch

OFF or ON

OFF: Hazard warning signal switch off

-

ON: Hazard warning signal switch on

Multi Switch (Back)

Steering pad switch (Back)

OFF or ON

OFF: Switch released

-

ON: Switch pushed

Passenger Occupant Detection Switch

Front passenger side seat condition

OFF or ON

ON: Front passenger seat occupied

-

OFF: Front passenger seat not occupied

Driver Side Seatbelt Buckle Switch

Driver Side Seatbelt Buckle Switch

OFF or ON

ON: Driver side seat belt fastened

-

OFF: Driver side seat belt unfastened

Key Remind Sound*2

Cycle of key reminder warning buzzer

Normal, Slow or Fast

Cycle of key reminder warning buzzer is Fast, Normal or Slow

The current setting of the cycle of the key reminder warning buzzer is displayed.

Key Remind Volume*2

Cycle of key reminder warning buzzer

Large, Small or Medium

Cycle of key reminder warning buzzer is Large, Medium or Small

The current setting of the cycle of the key reminder warning buzzer is displayed.

Driver Side Seatbelt Warning Buzzer

Condition of the driver side seat belt warning buzzer

OFF or ON

ON: Driver side seat belt warning buzzer sounds at a vehicle speed of 20 km/h (12 mph) or more when driver side seat belt unfastened

The customized setting of the driver side seat belt warning buzzer is displayed.

OFF: Driver side seat belt warning buzzer does not sound at a vehicle speed of 20 km/h (12 mph) or more when driver side seat belt unfastened

P-Seatbelt Warning Buzzer

Condition of the front passenger side seat belt warning buzzer

OFF or ON

ON: Front passenger side seat belt warning buzzer sounds at a vehicle speed of 20 km/h (12 mph) or more when front passenger side seat belt unfastened

The customized setting of the front passenger side seat belt warning buzzer is displayed.

OFF: Front passenger side seat belt warning buzzer does not sound at a vehicle speed of 20 km/h (12 mph) or more when front passenger side seat belt unfastened

ODO Display Time After IG OFF Setting

Condition of the ODO display time after the ignition switch is turned off

30s, 60s, 600s or OFF

Displays customize setting of ODO display time after IG off setting

-

Lane Change Flashing Times Setting

Condition of the lane change flashing times

OFF, 3, 4, 5, 6 or 7

Displays customize setting of lane change flashing times setting

-

Flasher Sound Volume Adjustment

Condition of the flasher sound volume adjustment

Small, Medium or Large

Displays customize setting of flasher sound volume adjustment

-

LDA System*3

Existence of lane departure alert system

With or Without

With: w/ Lane departure alert system

-

Without: w/o Lane departure alert system

PCS System*3

Existence of pre-collision system

With or Without

With: w/ Pre-collision system

-

Without: w/o Pre-collision system

Radar Cruise System*3

Existence of dynamic radar cruise control system

With or Without

With: w/ Dynamic radar cruise control system

-

Without: w/o Dynamic radar cruise control system

Number of Trouble Code

The number of the DTC which is currently output

Min.: 0, Max.: 255

0

-
  • *1: w/ Maintenance Required Reminder
  • *2: w/o Smart Key System
  • *3: w/ Toyota Sefety Sense P

2. ACTIVE TEST

HINT:

Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

(a) Warm up the engine.

(b) Turn the ignition switch off.

(c) Connect the Techstream to the DLC3.

(d) Turn the ignition switch to ON.

(e) Turn the Techstream on.

(f) Enter the following menus: Body Electrical / Combination Meter / Active Test.

(g) According to the display on the Techstream, perform the Active Test.

Combination Meter

Tester Display

Test Part

Control Range

Diagnostic Note

Speed Meter Operation

Speedometer

OFF, 0, 40, 80, 120, 160

Operate with IG ON and the vehicle is stopped.

Acceptable range (km/h or mph): [Control range → Speedometer display]

for mph

  • 40 → 39.15 to 42.65
  • 80 → 79.65 to 84.15

for km/h

  • 40 → 38.95 to 42.95
  • 80 → 78.9 to 84.9
  • 120 → 119.8 to 125.8
  • 160 → 159.8 to 167.8

TachoMeter Operation

Tachometer

OFF, 0, 1000, 2000, 3000, 4000, 5000, 6000, 7000

Operate with IG ON and the vehicle is stopped.

Fuel Meter Operation

Fuel receiver gauge

OFF, Sender E, Empty, Warning, 1/4, 1/2, 3/4, Full, Sender F

Operate with IG ON and the vehicle is stopped.

A/T Indicator Operation 1

A/T shift indicator light (D, P, N. R, 4, 3, 2, L)

OFF, L, 2, 3 (M), 4 (M), D, N, R, P

Operate with IG ON and the vehicle is stopped.

A/T Indicator Operation 2

A/T gear range indicator light (S, 6, 5)

OFF, 8, 5, 6, 7, Es, M, S, B

Operate with IG ON and the vehicle is stopped.

Indicat. Lamp Airbag

SRS warning light

OFF or ON

Operate with IG ON and the vehicle is stopped.

Driver Side Seat Belt

Driver side seat belt warning light

OFF or ON

Operate with IG ON and the vehicle is stopped.

Indicat. Lamp ABS

ABS warning light

OFF or ON

Operate with IG ON and the vehicle is stopped.

Indicat. Lamp Slip

Slip indicator light

OFF or ON

Operate with IG ON and the vehicle is stopped.

Indicat. Lamp Beam

High beam indicator light

OFF or ON

Operate with IG ON and the vehicle is stopped.

Indicat. Lamp Head*1

Head indicator light

OFF or ON

Operate with IG ON and the vehicle is stopped.

Indicat. Lamp Tail*2

Tail indicator light

OFF or ON

Operate with IG ON and the vehicle is stopped.

Indicat. Lamp Fr FOG*3

Front fog indicator light

OFF or ON

Operate with IG ON and the vehicle is stopped.

Indicat. Pre-Collision*4

PCS warning light

OFF or ON

Operate with IG ON and the vehicle is stopped.

Indicat. Lamp Fuel

Fuel level warning light

OFF or ON

Operate with IG ON and the vehicle is stopped.

Indicat. Tire Pressure Warning System

Tire Pressure warning light

OFF or ON

Operate with IG ON and the vehicle is stopped.

Indicat. ECONO

Eco Driving Indicator Light

OFF or ON

Operate with IG ON and the vehicle is stopped.

Indicat. Lamp Brake

Brake warning light

OFF or ON

Operate with IG ON and the vehicle is stopped.

Indicat. EPS

Power steering warning light

OFF or ON

Operate with IG ON and the vehicle is stopped.

Master Warning

Master warning light

OFF or ON

Operate with IG ON and the vehicle is stopped.

Indicat. VSC OFF

VSC OFF indicator light

OFF or ON

Operate with IG ON and the vehicle is stopped.

Automatic High Beam Indicator*4

Automatic high beam indicator light

OFF or ON

Operate with IG ON and the vehicle is stopped.

Turn Signal (Left) Indicator

LH turn indicator light

OFF or ON

Operate with IG ON and the vehicle is stopped.

Turn Signal (Right) Indicator

RH turn indicator light

OFF or ON

Operate with IG ON and the vehicle is stopped.

Check Engine Indicator

MIL (Check engine warning light)

OFF or ON

Operate with IG ON and the vehicle is stopped.

Water Temperature Meter Operation

Engine coolant temperature receiver gauge

OFF, LOW, NORMAL, HIGH

Operate with IG ON and the vehicle is stopped.

Meter Display 1

Multi-information display

OFF, 6, 5, 4, 3, 2, 1, 0, All

Operate with IG ON and the vehicle is stopped.
  • *1: for U.S.A.
  • *2: except U.S.A.
  • *3: w/ Front Fog Light
  • *4: w/ Toyota Safety Sense P