ECM
|
Vehicle Identification Number (VIN) registration
|
MIL comes on
|
|
ECU communication ID registration (Engine immobiliser system)
|
Engine start
|
*1
*2
|
-
Throttle body with motor assembly
-
Cleaning the deposits from the throttle body with motor assembly
-
Engine assembly
-
Cylinder head sub-assembly
-
Camshaft (for intake or exhaust camshaft)
-
Camshaft timing gear assembly
-
Camshaft timing exhaust gear assembly
-
Piston or piston ring
-
Mass air flow meter
-
Fuel injector assembly (for port injection)
-
Fuel injector assembly (for direct injection)
-
Fuel pump (for low pressure side)
-
Fuel pump assembly (for high pressure side)
-
Fuel pressure sensor (for low pressure side)
-
Fuel pressure sensor (for high pressure side)
-
Air fuel ratio sensor
-
Heated oxygen sensor
-
Engine coolant temperature sensor
-
Spark plug
-
Ignition coil assembly
-
Air leaks from intake system
-
Gas leaks from exhaust system
-
Knock sensor
|
Inspection after repair
|
-
Poor idle, etc.
-
Engine start function, etc.
|
|
Automatic transaxle assembly
|
-
Reset memory
-
Input transaxle compensation code into ECM
-
Perform road test to allow ECM to Learn
|
-
Large shift shock
-
The deterioration of fuel efficiency
|
for UA80E Initialization
for UA80E Registration
for UA80F Initialization
for UA80F Registration
|
-
Valve body assembly
-
Shift solenoid valve SL1, SL2, SL3, SL4, SL5 and/or SL6
|
-
Reset memory
-
Reset transaxle compensation code
-
Perform road test to allow ECM to learn
|
ECM (If possible, read the transaxle compensation code from the previous ECM)
|
Possible to read transaxle compensation code
|
-
Reset memory
-
Transfer transaxle compensation code
-
Perform road test to allow ECM to learn
|
Impossible to read transaxle compensation code
|
-
Reset memory
-
Reset transaxle compensation code
-
Input transaxle compensation code into ECM
-
Perform road test to allow ECM to learn
|
Engine assembly
|
Perform road test to allow ECM to Learn
|
-
Tire pressure warning ECU
-
Tire pressure warning valve and transmitter
|
-
Register transmitter IDs
-
Initialize tire pressure warning system
|
-
When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.
-
Tire pressure warning function
|
|
-
Brake actuator assembly (Skid control ECU)
-
Yaw rate and acceleration sensor
|
Perform yaw rate and acceleration sensor zero point calibration and store system information
|
-
ABS warning light illumination
-
Slip indicator light illumination
-
VSC disabled or malfunctioning
|
|
Steering column assembly
|
Assist map writing
|
-
EPS warning light comes on
-
EPS control
|
|
Parking assist ECU
|
Parking assist ECU initialization
|
Parking assist monitor system
|
|
Rear television camera
|
Back camera position setting
|
Parking assist monitor system
|
|
Blind spot monitor sensor LH/RH*3
|
Blind spot monitor beam axis inspection
|
DTCs are output
|
|
DCM (Telematics Transceiver)
|
DCM activation
|
Safety connect system done not operative
|
|
-
Certification ECU (smart key ECU assembly)*1
-
Steering lock ECU (steering lock actuator assembly)*1
-
Key*1
|
Code registration (Engine immobiliser system*1
|
-
Wireless door lock control system
-
Smart key system
-
Engine start
|
|
Transponder key ECU*2
|
-
Key code registration
-
ECU communication ID registration
|
Engine start
|
|
-
Door control transmitter*2
-
Door control receiver*2
|
Registration of recognition code (Wireless door lock control system*2
|
Wireless door lock control system
|
|
-
Occupant classification ECU
-
Front passenger seat
|
-
Zero point calibration (Occupant classification system)
-
Sensitivity check (Occupant classification system)
|
-
Occupant classification system
-
Passenger airbag ON/OFF indicator
-
Airbag system (Front passenger side)
-
Seat belt warning system (Front passenger side)
|
|
Position control ECU assembly
|
-
Initialize position information
-
Configure limit switch starting position
|
Auto access seat system
|
|
Fold seat control ECU
|
Position memory initialization
|
Rear power seat control system
|
|
-
Front power window regulator motor assembly LH
-
Front power window regulator motor assembly RH
-
Rear power window regulator motor assembly LH
-
Rear power window regulator motor assembly RH
|
Motor initialization
|
Power window control system
|
|
-
Sliding roof ECU (sliding roof drive gear assembly)
-
Sliding roof glass
-
Sliding roof housing
|
Initializing sliding roof ECU (pulse sensor initial position setting)
|
-
Automatic slide open, tilt up function of sliding roof
-
Jam protection function
|
|