- Vehicle speed sensors
- Vehicle speed sensor signal circuit
- Combination meter assembly
- ECM
| Last Modified: 04-05-2023 | 6.11:8.1.0 | Doc ID: RM100000000ZX6N |
| Model Year Start: 2017 | Model: Sienna | Prod Date Range: [08/2016 - 11/2017] |
| Title: CRUISE CONTROL: DYNAMIC RADAR CRUISE CONTROL SYSTEM: P050013,P05001F; Vehicle Speed Sensor "A" Circuit Open; 2017 MY Sienna [08/2016 - 11/2017] | ||
|
DTC |
P050013 |
Vehicle Speed Sensor "A" Circuit Open |
|
DTC |
P05001F |
Vehicle Speed Sensor "A" Circuit Intermittent |
DESCRIPTION
The dynamic radar cruise control system uses the same vehicle speed signal that is sent to the ECM for the SFI system. If DTC P050013 and P05001F is detected, perform the diagnosis using the inspection procedure for DTC P050013 and P05001F in the SFI system (See page
![2017 MY Sienna [08/2016 - 11/2017]; 2GR-FKS (ENGINE CONTROL): SFI SYSTEM: P050031; Vehicle Speed Sensor "A" No Signal](/t3Portal/stylegraphics/info.gif)
). The speed signal is converted for use by the cruise control inside the ECM. Both the SFI system and the dynamic radar cruise control system can set DTC P050013 and P05001F, however, the detection conditions of the two systems are different.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
MIL |
|---|---|---|---|
|
P050013 |
The vehicle speed signal from the vehicle speed sensor is cut for 0.14 seconds or more while cruise control is in operation |
|
Does not come on |
|
P05001F |
A momentary interruption and noise are detected when a rapid change of the vehicle speed occurs while cruise control is in operation. |
|
Does not come on |
WIRING DIAGRAM
CAUTION / NOTICE / HINT
This DTC may be output by the vehicle stability control system at the same time. In that case, perform troubleshooting for the vehicle stability control system first.
PROCEDURE
|
1. |
CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM) |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.
(e) Check for DTCs.
Result
|
Result |
Proceed to |
|---|---|
|
DTC is not output |
A |
|
DTC is output |
B |
| B |
|
|
|
2. |
REPLACE COMBINATION METER ASSEMBLY |
(a) Replace the combination meter assembly (See page
).
|
|
3. |
CHECK DTC (CRUISE CONTROL SYSTEM) |
(a) Clear the DTCs (See page
).
(b) Perform the following to make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the malfunction cannot be detected.
(1) Drive the vehicle at a speed of 50 km/h (30 mph) or more.
(2) Turn the cruise control main switch on.
(3) Push the -SET switch to activate the cruise control.
(c) Check for DTCs (See page
).
Result
|
Result |
Proceed to |
|---|---|
|
DTC is not output |
A |
|
DTC is output |
B |
| A |
|
END |
| B |
|
|
|