Last Modified: 04-05-2023 6.11:8.1.0 Doc ID: RM100000000ZAPA
Model Year Start: 2017 Model: Sienna Prod Date Range: [08/2016 -           ]
Title: 2GR-FKS LUBRICATION: OIL PRESSURE SWITCH: INSTALLATION; 2017 - 2020 MY Sienna [08/2016 -        ]

INSTALLATION

PROCEDURE

1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

(a) Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

NOTICE:

  • Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.
  • Install the engine oil pressure switch assembly within 3 minutes of applying adhesive.

*a

Adhesive 1344

*b

Oil Inlet Port

(b) Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

Torque:

15 N·m {153 kgf·cm, 11 ft·lbf}

NOTICE:

Do not start the engine for at least 1 hour after installation.

(c) Connect the engine oil pressure switch assembly connector.

(d) Connect the wire harness protector.

2. ADD ENGINE OIL

Click here 2017 - 2020 MY Sienna [08/2016 -        ]; 2GR-FKS LUBRICATION: OIL AND OIL FILTER: REPLACEMENT+

3. CHECK ENGINE OIL LEVEL

Click here 2017 - 2020 MY Sienna [08/2016 -        ]; 2GR-FKS LUBRICATION: LUBRICATION SYSTEM: ON-VEHICLE INSPECTION+

4. INSPECT FOR ENGINE OIL LEAK

Click here 2017 - 2020 MY Sienna [08/2016 -        ]; 2GR-FKS LUBRICATION: OIL AND OIL FILTER: REPLACEMENT+

5. INSTALL FRONT FENDER APRON SEAL RH

Click here 2017 - 2020 MY Sienna [08/2016 -        ]; 2GR-FKS (ENGINE MECHANICAL): ENGINE ASSEMBLY: INSTALLATION+