| Last Modified: 04-05-2023 | 6.11:8.1.0 | Doc ID: RM100000000YW9Q |
| Model Year Start: 2017 | Model: Sienna | Prod Date Range: [08/2016 - ] |
| Title: 2GR-FKS (ENGINE MECHANICAL): REAR CRANKSHAFT OIL SEAL: INSTALLATION; 2017 - 2020 MY Sienna [08/2016 - ] | ||
INSTALLATION
PROCEDURE
1. INSTALL REAR ENGINE OIL SEAL
|
(a) Apply MP grease to the lip of a new rear engine oil seal. |
|
(b) Using SST and a hammer, tap in the rear engine oil seal.
SST: 09223-15030
SST: 09950-70010
09951-07150
Oil Seal Protrusion Height:
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
NOTICE:
- Keep the lip free from foreign matter.
- Do not tap in the rear engine oil seal at an angle.
2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY
|
(a) Using SST, hold the crankshaft pulley. SST: 09213-70011 09213-70020 SST: 09330-00021 |
|
(b) Clean the 8 bolts and 8 bolt holes.
|
(c) Install the No. 1 crankshaft position sensor plate to the crankshaft. HINT: Align the pin of the No. 1 crankshaft position sensor plate with the pin hole of the crankshaft. |
|
(d) Install the drive plate and ring gear sub-assembly and rear drive plate spacer to the crankshaft.
|
*1 |
Drive Plate and Ring Gear Sub-assembly |
|
*2 |
Rear Drive Plate Spacer |
|
Transaxle Side |
|
(e) Apply adhesive to 2 or 3 threads at the end of each of the 8 bolts. Adhesive: Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent |
|
|
(f) Install and uniformly tighten the 8 bolts in several steps in the sequence shown in the illustration. Torque: 83 N·m {846 kgf·cm, 61 ft·lbf} NOTICE: Do not start the engine for at least 1 hour after installing the drive plate and ring gear sub-assembly. |
|
3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY
-
for UA80E:
Click here
![2017 - 2020 MY Sienna [08/2016 - ]; UA80E (AUTOMATIC TRANSMISSION / TRANSAXLE): AUTOMATIC TRANSAXLE ASSEMBLY: INSTALLATION](/t3Portal/stylegraphics/info.gif)
-
for UA80F:
Click here
4. INSPECT FOR ENGINE OIL LEAK
Click here
|
|