Last Modified: 04-05-2023 6.11:8.1.0 Doc ID: RM100000000YW9C
Model Year Start: 2017 Model: Sienna Prod Date Range: [08/2016 -           ]
Title: 2GR-FKS (ENGINE MECHANICAL): DRIVE BELT: INSTALLATION; 2017 - 2020 MY Sienna [08/2016 -        ]

INSTALLATION

PROCEDURE

1. INSTALL FAN AND GENERATOR V BELT

(a) Install the fan and generator V belt.

NOTICE:

  • Make sure to put the backside of the fan and generator V belt on the V-ribbed belt tensioner assembly pulley and No. 2 idler pulley sub-assembly.
  • Check that the fan and generator V belt is properly set to each pulley.

*1

Engine Water Pump Assembly

*2

No. 2 Idler Pulley Sub-assembly

*3

Generator Assembly

*4

Crankshaft Pulley

*5

V-ribbed Belt Tensioner Assembly

*6

Compressor Assembly with Pulley

(b) Turn the V-ribbed belt tensioner assembly counterclockwise and remove the 5 mm hexagon wrench.

(c) After installing the fan and generator V belt, check that it fits properly in the ribbed grooves. Confirm that the fan and generator V belt has not slipped out of the grooves on the bottom of the pulley by hand.

*a

Correct

*b

Incorrect

2. INSTALL FRONT FENDER APRON SEAL RH

Click here 2017 - 2020 MY Sienna [08/2016 -        ]; 2GR-FKS (ENGINE MECHANICAL): ENGINE ASSEMBLY: INSTALLATION+

3. INSTALL FRONT WHEEL RH

Torque:

103 N·m {1050 kgf·cm, 76 ft·lbf}