INSTALLATION

PROCEDURE

1. INSTALL FAN AND GENERATOR V BELT

(a) Install the fan and generator V belt. NOTICE: Make sure to put the backside of the fan and generator V belt on the V-ribbed belt tensioner assembly pulley and No. 2 idler pulley sub-assembly. Check that the fan and generator V belt is properly set to each pulley.

*1 Engine Water Pump Assembly *2 No. 2 Idler Pulley Sub-assembly *3 Generator Assembly *4 Crankshaft Pulley *5 V-ribbed Belt Tensioner Assembly *6 Compressor Assembly with Pulley

(b) Turn the V-ribbed belt tensioner assembly counterclockwise and remove the 5 mm hexagon wrench.

(c) After installing the fan and generator V belt, check that it fits properly in the ribbed grooves. Confirm that the fan and generator V belt has not slipped out of the grooves on the bottom of the pulley by hand.

*a Correct *b Incorrect

2. INSTALL FRONT FENDER APRON SEAL RH

Click here

3. INSTALL FRONT WHEEL RH

Torque:

103 N·m {1050 kgf·cm, 76 ft·lbf}