Last Modified: 04-05-2023 6.11:8.1.0 Doc ID: RM100000000YS0M
Model Year Start: 2017 Model: Sienna Prod Date Range: [08/2016 -           ]
Title: LIGHTING (INT): LIGHTING SYSTEM: Engine Switch Illumination Circuit; 2017 - 2020 MY Sienna [08/2016 -        ]

Engine Switch Illumination Circuit

DESCRIPTION

The illuminated entry system controls the engine switch illumination.

WIRING DIAGRAM

PROCEDURE

1.

PERFORM ACTIVE TEST USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Smart Key / Active Test.

(e) According to the display on the Techstream, perform the Active Test.

Smart Key

Tester Display

Test Part

Control Range

Diagnostic Note

Power/Engine SW Light

Engine switch illumination

ON/OFF

-

OK:

Engine switch illumination comes on.

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.

INSPECT ENGINE SWITCH

(a) Remove the engine switch.

Click here 2017 - 2020 MY Sienna [08/2016 -        ]; 2GR-FKS STARTING: ENGINE SWITCH: REMOVAL

*a

Component without harness connected

(Engine Switch)

*b

Illumination

(b) Apply battery voltage to the terminals and check that the engine switch comes on.

OK:

Measurement Condition

Specified Condition

Battery positive (+) → Terminal 11 (SWIL)

Battery negative (-) → Terminal 5 (GND)

Engine switch illumination comes on

(c) Reinstall the engine switch.

Click here 2017 - 2020 MY Sienna [08/2016 -        ]; 2GR-FKS STARTING: ENGINE SWITCH: INSTALLATION

NG

REPLACE ENGINE SWITCH

OK

3.

CHECK HARNESS AND CONNECTOR (ENGINE SWITCH - CERTIFICATION ECU AND BODY GROUND)

(a) Disconnect the D33 engine switch connector.

(b) Disconnect the D88 certification ECU (smart key ECU assembly) connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

D33-11 (SWIL) - D88-11 (SWIL)

Always

Below 1 Ω

D33-5 (GND) - Body ground

Always

Below 1 Ω

D33-11 (SWIL) - Body ground

Always

10 kΩ or higher

(d) Reconnect the certification ECU (smart key ECU assembly) connector.

(e) Reconnect the engine switch connector.

OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) 2016 - 2017 MY Sienna [12/2015 - 11/2017]; THEFT DETERRENT / KEYLESS ENTRY: CERTIFICATION ECU: REMOVAL 2018 - 2020 MY Sienna [11/2017 -        ]; THEFT DETERRENT / KEYLESS ENTRY: CERTIFICATION ECU: REMOVAL

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR