2GR-FKS (FUEL): FUEL SENDER GAUGE ASSEMBLY: REMOVAL; 2017 - 2020 MY Sienna [08/2016

Last Modified: 04-05-2023	6.11:8.1.0	Doc ID: RM100000000YQSR
Model Year Start: 2017	Model: Sienna	Prod Date Range: [08/2016 - ]
Title: 2GR-FKS (FUEL): FUEL SENDER GAUGE ASSEMBLY: REMOVAL; 2017 - 2020 MY Sienna [08/2016 - ]

REMOVAL

1. DISCHARGE FUEL SYSTEM PRESSURE

Click here

2. REMOVE CHARCOAL CANISTER PROTECTOR

Click here

3. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

Click here

4. DRAIN FUEL

Click here

5. REMOVE CENTER EXHAUST PIPE ASSEMBLY (for 2WD)

Click here

6. REMOVE NO. 1 FUEL TANK HEAT INSULATOR (for 2WD)

Click here

7. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for AWD)

Click here

8. DISCONNECT FUEL TANK VENT HOSE

Click here

9. DISCONNECT CHARCOAL CANISTER OUTLET TUBE SUB-ASSEMBLY

Click here

10. REMOVE REAR FLOOR NO. 2 CROSSMEMBER BRACE LH

Click here

11. REMOVE FUEL TANK FILLER HOSE COVER

Click here

12. DISCONNECT FUEL TANK INLET PIPE SUB-ASSEMBLY

Click here

13. REMOVE FUEL TANK ASSEMBLY

Click here

14. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

(a) Widen the tip of the tube joint clip and pull out the clip in the direction indicated by the arrow.

NOTICE:

Check for dirt or other foreign matter on the parts to be disconnected and clean them if necessary.
The fuel tube connector seals with an O-ring. Ensure that there is no damage or foreign matter on the contact surface.
Do not use any tools.
Do not bend or twist the tubes.
Protect the contact surface by covering it with a plastic bag.
If the connector is stuck, push and pull on the parts to separate them.

(b) Pull the fuel tank main tube out of the fuel suction with pump and gauge tube assembly to disconnect it.

15. REMOVE FUEL PUMP GAUGE RETAINER

Click here

16. REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY

Click here

17. REMOVE FUEL SUCTION TUBE SET GASKET

Click here

18. REMOVE FUEL SENDER GAUGE ASSEMBLY

(a) Disconnect the fuel sender gauge connector and disengage the harness clamp.

NOTICE:

Do not damage the wire harness.

(b) Release the lock as shown in the illustration and remove the fuel sender gauge by sliding it.