Last Modified: 04-05-2023 6.11:8.1.0 Doc ID: RM100000000WPI4
Model Year Start: 2016 Model: Sienna Prod Date Range: [12/2015 - 08/2016]
Title: THEFT DETERRENT / KEYLESS ENTRY: ENGINE IMMOBILISER SYSTEM(w/o Smart Key System): HOW TO PROCEED WITH TROUBLESHOOTING; 2016 MY Sienna [12/2015 - 08/2016]

HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

HINT:

Use the following procedure to troubleshoot the engine immobiliser system.

*: Use the Techstream.

PROCEDURE

1.

VEHICLE BROUGHT TO WORKSHOP

NEXT

2.

CUSTOMER PROBLEM ANALYSIS

(a) Interview the customer to confirm the trouble.

Click here 2016 MY Sienna [12/2015 - 08/2016]; INTRODUCTION: HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS: HOW TO PROCEED WITH TROUBLESHOOTING

NEXT

3.

INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

NEXT

4.

CRANK ENGINE FOR MORE THAN 10 SECONDS

NEXT

5.

CHECK FOR DTCS (ENGINE IMMOBILISER SYSTEM)*

(a) Check for DTCs and note any codes that are output.

(b) Clear the DTCs.

Click here 2016 MY Sienna [12/2015 - 08/2016]; THEFT DETERRENT / KEYLESS ENTRY: ENGINE IMMOBILISER SYSTEM(w/o Smart Key System): DTC CHECK / CLEAR

(c) Recheck for DTCs. Based on the DTCs output above, try to duplicate the engine immobiliser system DTC by simulating the symptoms indicated by the DTCs.

Result

Proceed to

No DTCs are output

A

Engine immobiliser system DTC is output

B

B

GO TO DIAGNOSTIC TROUBLE CODE CHART

A

6.

CHECK FOR DTCS (SFI SYSTEM)*

(a) Clear the DTCs.

Click here 2016 MY Sienna [12/2015 - 08/2016]; THEFT DETERRENT / KEYLESS ENTRY: ENGINE IMMOBILISER SYSTEM(w/o Smart Key System): DTC CHECK / CLEAR

(b) Recheck for DTCs.

HINT:

The DTCs for the engine immobiliser system are specified below. If other DTCs are output, check the DTC chart for the SFI system.

Result

Proceed to

No DTCs are output

A

Engine immobiliser system DTC is output (DTC B2799, B279A or B279C)

B

SFI system DTC is output (except DTC B2799, B279A and B279C)

C

B

GO TO DIAGNOSTIC TROUBLE CODE CHART

C

GO TO SFI SYSTEM

A

7.

READ VALUE USING TECHSTREAM*

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Immobiliser / Data List.

(e) Read the Data List according to the display on the Techstream.

Immobiliser

Tester Display

Measurement Item/Range

Normal Condition

Diagnostic Note

Key SW

Unlock warning switch signal/ON or OFF

ON: Key in ignition key cylinder

OFF: No key in ignition key cylinder

-

OK:

On the Techstream screen, the item changes between ON and OFF according to the chart above.

NG

GO TO DTC B2780

OK

8.

PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table.

Click here 2016 MY Sienna [12/2015 - 08/2016]; THEFT DETERRENT / KEYLESS ENTRY: ENGINE IMMOBILISER SYSTEM(w/o Smart Key System): PROBLEM SYMPTOMS TABLE

Result

Proceed to

Fault is not listed in Problem Symptoms Table

A

Fault is listed in Problem Symptoms Table

B

B

GO TO STEP 10

A

9.

OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Data List / Active Test

Click here 2016 - 2020 MY Sienna [12/2015 -        ]; THEFT DETERRENT / KEYLESS ENTRY: ENGINE IMMOBILISER SYSTEM(w/o Smart Key System): DATA LIST / ACTIVE TEST

(b) Terminals of ECU

Click here 2016 MY Sienna [12/2015 - 08/2016]; THEFT DETERRENT / KEYLESS ENTRY: ENGINE IMMOBILISER SYSTEM(w/o Smart Key System): TERMINALS OF ECU

NEXT

10.

REPAIR OR REPLACE

NEXT

11.

CONFIRMATION TEST

NEXT

END