Last Modified: 04-05-2023 |
6.11:8.1.0 |
Doc ID: RM100000000WPEM |
Model Year Start: 2016 |
Model: Sienna |
Prod Date Range: [12/2015 -
] |
Title: STEERING COLUMN: STEERING LOCK SYSTEM: HOW TO PROCEED WITH TROUBLESHOOTING; 2016 - 2020 MY Sienna [12/2015 - ] |
HOW TO PROCEED WITH TROUBLESHOOTING
|
CAUTION / NOTICE / HINT
HINT:
-
Use the following procedures to troubleshoot the steering lock system.
-
*: Use the Techstream.
PROCEDURE
1.
|
VEHICLE BROUGHT TO WORKSHOP
|
NEXT
|
|
|
2.
|
INSPECT BATTERY VOLTAGE
|
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
NEXT
|
|
|
(a) Check for DTCs and make a note of any codes that are output.
Click here
(b) Clear the DTCs
Click here
(c) Recheck for DTCs
.Based on the DTCs output above, try to cause the output of the same wireless door lock control system DTC, LINcommunication system DTC, steering lock system DTC,engine immobiliser system DTC or smart key system (forentry function) DTC by reproducing the symptomsindicated by the DTC.
Result
|
Proceed to
|
DTC is not output.
|
A
|
Wireless door lock control system DTC is output.
|
B
|
LIN communication system DTC is output.
|
C
|
Steering lock system DTC is output.
|
D
|
Engine immobiliser system DTC is output.
|
E
|
Smart key system (for entry function) DTC is output.
|
F
|
A
|
|
|
4.
|
PROBLEM SYMPTOMS TABLE
|
(a) Refer to Problem Symptoms Table.
Click here
Result
|
Proceed to
|
Fault is not listed in problem symptoms table.
|
A
|
Fault is listed in problem symptoms table.
|
B
|
A
|
|
|
5.
|
OVERALL ANALYSIS AND TROUBLESHOOTING*
|
(a) Terminals of ECU.
Click here
(b) Data List / Active Test.
Click here
NEXT
|
|
|
NEXT
|
|
|
NEXT |
|
END
|
|