Last Modified: 04-05-2023 6.11:8.1.0 Doc ID: RM100000000VKIQ
Model Year Start: 2016 Model: Sienna Prod Date Range: [12/2015 - 11/2017]
Title: EXTERIOR PANELS / TRIM: FRONT BUMPER: INSTALLATION; 2016 - 2017 MY Sienna [12/2015 - 11/2017]

INSTALLATION

PROCEDURE

1. INSTALL FRONT BUMPER COVER

(a) Engage the 10 claws and install the front bumper cover

(b) Connect the connectors.

HINT:

If the vehicle is equipped with fog lights, connect the connector.

(c) Tighten the 6 screws.

(d) Install the 3 clips.

(e) Install the pin hold clip.

NOTICE:

Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is vertical.

HINT:

Use the same procedure for the remaining part.

(f) Install the screw.

HINT:

Use the same procedure for the remaining part.

2. INSTALL RADIATOR GRILLE SUB-ASSEMBLY

(a) Engage the 8 guides and install the radiator grille.

(b) Install the 6 clips.

3. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH

(a) Install the front wheel opening extension pad with the 4 screws.

Torque:

7.0 N·m {71 kgf·cm, 62 in·lbf}

for screw A

4. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

HINT:

Use the same procedure as for the LH side.

5. PREPARE VEHICLE FOR FOG LIGHT AIMING ADJUSTMENT (w/ Fog Light)

2016 - 2020 MY Sienna [12/2015 -        ]; LIGHTING (EXT): FOG LIGHT ASSEMBLY: ADJUSTMENT+

6. PREPARE FOR FOG LIGHT AIMING (w/ Fog Light)

2016 - 2020 MY Sienna [12/2015 -        ]; LIGHTING (EXT): FOG LIGHT ASSEMBLY: ADJUSTMENT+

7. INSPECT FOG LIGHT AIMING (w/ Fog Light)

2016 - 2020 MY Sienna [12/2015 -        ]; LIGHTING (EXT): FOG LIGHT ASSEMBLY: ADJUSTMENT+

8. ADJUST FOG LIGHT AIMING (w/ Fog Light)

2016 - 2020 MY Sienna [12/2015 -        ]; LIGHTING (EXT): FOG LIGHT ASSEMBLY: ADJUSTMENT+