INSTALLATION

PROCEDURE

1. INSTALL REAR WIPER MOTOR GROMMET

(a) Apply MP grease to the entire surface of the rear wiper motor grommet lip. Text in Illustration *1 MP grease HINT: Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease.

(b) Install the rear wiper motor grommet with the position mark facing downward as shown in the illustration. Text in Illustration *1 Position Mark

2. INSTALL REAR WIPER MOTOR AND BRACKET ASSEMBLY

(a) Install the rear wiper motor and bracket assembly with the 3 bolts.

Torque:

5.5 N·m {56 kgf·cm, 49 in·lbf}

(b) Connect the rear wiper motor connector.

(c) Engage the harness clamp.

3. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY

(a) Operate the wiper and stop the rear wiper motor at the automatic stop position.

(b) When reusing the rear wiper arm and blade assembly:

(1) Clean the wiper arm serrations. Text in Illustration *1 Wiper Arm Serrations

(c) When reusing the rear wiper motor assembly:

(1) Clean the wiper pivot serrations with a wire brush. Text in Illustration *1 Wire Brush *2 Wiper Pivot Serrations

(d) Install the rear wiper arm and blade assembly with the nut to the position shown in the illustration. Text in Illustration *1 Ceramic Void Torque: 5.5 N·m {56 kgf·cm, 49 in·lbf} HINT: Hold the wiper arm by hand while tightening the nut.

(e) Operate the rear wiper while spraying washer fluid onto the back door glass. Make sure that the rear wiper functions properly and the wiper does not come into contact with the vehicle body.

4. INSTALL NO. 6 REAR SPOILER PROTECTOR

5. INSTALL NO. 5 REAR SPOILER PROTECTOR

6. INSTALL NO. 10 REAR SPOILER PROTECTOR

7. INSTALL NO. 4 REAR SPOILER PROTECTOR

8. INSTALL NO. 3 REAR SPOILER PROTECTOR

9. INSTALL NO. 3 REAR SPOILER PROTECTOR

10. INSTALL NO. 2 REAR SPOILER PROTECTOR

11. INSTALL NO. 2 REAR SPOILER PROTECTOR

12. INSTALL NO. 2 REAR SPOILER PROTECTOR

13. INSTALL REAR SPOILER SUB-ASSEMBLY

14. INSTALL BACK DOOR CENTER GARNISH