Last Modified: 04-05-2023 |
6.11:8.1.0 |
Doc ID: RM100000000VK8D |
Model Year Start: 2016 |
Model: Sienna |
Prod Date Range: [12/2015 - 11/2017] |
Title: DOOR / HATCH: HOOD LOCK CONTROL CABLE ASSEMBLY: REMOVAL; 2016 - 2017 MY Sienna [12/2015 - 11/2017] |
REMOVAL
PROCEDURE
1. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH
(a) Remove the 4 screws and the front wheel opening extension pad LH.
|
|
2. SEPARATE FRONT FENDER LINER LH
(a) Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
|
|
(c) Remove the 2 screws.
3. REMOVE RADIATOR GRILLE SUB-ASSEMBLY
4. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)
5. REMOVE HOOD LOCK NUT CAP
(a) Using a screwdriver with its tip wrapped in protective tape, remove the hood lock nut cap.
Text in Illustration
|
|
6. REMOVE HOOD LOCK ASSEMBLY
(a) Disconnect the connector.
|
|
(b) Remove the 3 bolts and hood lock.
(c) Disconnect the hood lock control cable.
7. REMOVE DOOR SCUFF PLATE ASSEMBLY LH
HINT:
Use the same procedure as for the RH side (See page
).
8. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
9. REMOVE COWL SIDE TRIM BOARD LH
HINT:
Use the same procedure as for the RH side (See page
).
10. REMOVE NO. 1 INSTRUMENT PANEL LOWER FINISH PANEL
11. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY
(a) Disconnect the hood lock control cable from hood lock control lever.
(b) Using a screwdriver with its tip wrapped in protective tape, disconnect the clamps shown in the illustration.
Text in Illustration
*1
|
Hood Lock Control Cable
|
-
|
-
|
(c) Pull the cable from the engine room and remove it.
|