| Last Modified: 04-05-2023 | 6.11:8.1.0 | Doc ID: RM100000000VK70 |
| Model Year Start: 2016 | Model: Sienna | Prod Date Range: [12/2015 - ] |
| Title: WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR(for Rear Door): REMOVAL; 2016 - 2020 MY Sienna [12/2015 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the LH side and RH side.
- The procedure listed below is the RH side.
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page
![2016 MY Sienna [12/2015 - 08/2016]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION](/t3Portal/stylegraphics/info.gif)
).
2. REMOVE REAR DOOR ARMREST BASE UPPER PANEL
3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
4. REMOVE REAR DOOR GLASS WEATHERSTRIP INNER WITH GARNISH
5. REMOVE SLIDE DOOR HANDLE ASSEMBLY (w/o Power Slide Door)
6. REMOVE SLIDE DOOR HANDLE ASSEMBLY (w/ Power Slide Door)
7. REMOVE REAR DOOR SCUFF PLATE
8. REMOVE QUARTER TRIM COVER HOLE
9. REMOVE REAR DOOR WIRE (w/o Power Slide Door)
10. REMOVE REAR DOOR WIRE (w/ Power Slide Door)
11. REMOVE QUARTER WINDOW GLASS (w/ Power Slide Door)
(See page
)
12. REMOVE SLIDE RAIL END MOULDING (w/ Power Slide Door)
13. REMOVE POWER SLIDE DOOR MOTOR UNIT (w/ Power Slide Door)
14. REMOVE SLIDE DOOR SERVICE HOLE COVER
15. REMOVE REAR DOOR WINDOW FRAME REAR MOULDING
HINT:
Use the same procedure as for the LH side (See page
).
16. REMOVE REAR DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY
HINT:
Use the same procedure as for the LH side (See page
).
17. REMOVE REAR DOOR GLASS RUN
18. REMOVE NO. 2 REAR DOOR GLASS RUN
19. REMOVE REAR DOOR GLASS SUB-ASSEMBLY
20. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY
21. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY
|
(a) Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly. |
|
|
|