Last Modified: 04-05-2023 |
6.11:8.1.0 |
Doc ID: RM100000000VK70 |
Model Year Start: 2016 |
Model: Sienna |
Prod Date Range: [12/2015 -
] |
Title: WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR(for Rear Door): REMOVAL; 2016 - 2020 MY Sienna [12/2015 - ] |
REMOVAL
CAUTION / NOTICE / HINT
HINT:
-
Use the same procedure for the LH side and RH side.
-
The procedure listed below is the RH side.
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page
).
2. REMOVE REAR DOOR ARMREST BASE UPPER PANEL
3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
4. REMOVE REAR DOOR GLASS WEATHERSTRIP INNER WITH GARNISH
5. REMOVE SLIDE DOOR HANDLE ASSEMBLY (w/o Power Slide Door)
6. REMOVE SLIDE DOOR HANDLE ASSEMBLY (w/ Power Slide Door)
7. REMOVE REAR DOOR SCUFF PLATE
8. REMOVE QUARTER TRIM COVER HOLE
9. REMOVE REAR DOOR WIRE (w/o Power Slide Door)
10. REMOVE REAR DOOR WIRE (w/ Power Slide Door)
11. REMOVE QUARTER WINDOW GLASS (w/ Power Slide Door)
(See page
)
12. REMOVE SLIDE RAIL END MOULDING (w/ Power Slide Door)
13. REMOVE POWER SLIDE DOOR MOTOR UNIT (w/ Power Slide Door)
14. REMOVE SLIDE DOOR SERVICE HOLE COVER
15. REMOVE REAR DOOR WINDOW FRAME REAR MOULDING
HINT:
Use the same procedure as for the LH side (See page
).
16. REMOVE REAR DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY
HINT:
Use the same procedure as for the LH side (See page
).
17. REMOVE REAR DOOR GLASS RUN
18. REMOVE NO. 2 REAR DOOR GLASS RUN
19. REMOVE REAR DOOR GLASS SUB-ASSEMBLY
20. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY
21. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY
(a) Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly.
|
|
|