| Last Modified: 04-05-2023 | 6.11:8.1.0 | Doc ID: RM100000000VK6W |
| Model Year Start: 2016 | Model: Sienna | Prod Date Range: [12/2015 - ] |
| Title: WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR(for Front Door): REMOVAL; 2016 - 2020 MY Sienna [12/2015 - ] | ||
REMOVAL
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The procedure listed below is for the RH side.
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page
![2016 MY Sienna [12/2015 - 08/2016]; INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION](/t3Portal/stylegraphics/info.gif)
).
2. REMOVE FRONT DOOR ARMREST BASE PANEL ASSEMBLY
3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
4. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
5. REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION
6. REMOVE COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)
7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
8. REMOVE OUTER MIRROR CONTROL ECU ASSEMBLY (w/ Memory)
9. REMOVE FRONT DOOR SERVICE HOLE COVER
10. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY
HINT:
Use the same procedure as for the LH side (See page
).
11. REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY
HINT:
Use the same procedure as for the LH side (See page
).
12. REMOVE FRONT DOOR CHECK ASSEMBLY
13. REMOVE FRONT DOOR WEATHERSTRIP
14. REMOVE FRONT DOOR GLASS RUN
15. REMOVE FRONT DOOR FRONT LOWER FRAME SUB-ASSEMBLY
16. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
17. REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY
18. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY
|
(a) Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly. |
|
|
|