DIAGNOSIS SYSTEM

1. DESCRIPTION

(a) Air conditioning system data and the Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform troubleshooting.

2. CHECK DLC3

(a) Check the DLC3 (See page ).

3. LIST OF OPERATION METHODS

(a) By operating each of the air conditioning control switches as shown in the diagram below, it is possible to enter diagnostic check mode.

4. INDICATOR CHECK

(a) Turn the ignition switch off.

(b) Turn the ignition switch to ACC and wait at least 5 seconds.

(c) Turn the ignition switch to ON while pressing the A/C control AUTO switch and recirculation/fresh switch simultaneously. Hold both switches until the indicator check screen appears.

(d) The indicator check is automatically performed when panel diagnosis is activated. Check that the indicators light up and go off 4 times at 1 second intervals continuously.

Text in Illustration

5. SENSOR CHECK (DTC CHECK)

(a) Start the engine and warm it up.

(b) Perform the indicator check.

HINT:

After the indicator check is completed, the system enters DTC check mode automatically.

(c) Read the DTC displayed on the display.

NOTICE:

In sensor check mode, which is automatically entered after indicator check mode, troubleshooting may be partially performed. Be sure to perform the actuator check, and then the sensor check again.

HINT:

Refer to Diagnostic Trouble Code Chart for details of the codes (See page ).

Text in Illustration

(d) If the steps are difficult to read because they change automatically, turn the driver side TEMP UP switch clockwise to display the steps one at a time so that they can be read easily. The items are displayed step by step each time the defroster switch is pressed.

HINT:

Press the OFF switch to finish panel diagnosis.

(e) Clear the DTC

(1) During the sensor check, press the defroster switch and rear defogger switch simultaneously.