Last Modified: 04-05-2023 6.11:8.1.0 Doc ID: RM100000000VJY5
Model Year Start: 2016 Model: Sienna Prod Date Range: [12/2015 -           ]
Title: SEAT: REAR NO. 2 SEAT ASSEMBLY(for Power Seat Type LH Side): INSTALLATION; 2016 - 2020 MY Sienna [12/2015 -        ]

INSTALLATION

PROCEDURE

1. INSTALL NO. 1 SEAT LEG BOX PROTECTOR

2016 - 2020 MY Sienna [12/2015 -        ]; SEAT: REAR NO. 2 SEAT ASSEMBLY(for Manual Seat Type LH Side): INSTALLATION+

2. INSTALL REAR NO. 2 SEAT LEG ASSEMBLY LH

(a) Install the rear No. 2 seat leg assembly LH and tighten the 3 bolts and 2 nuts in the order shown in the illustration.

Torque:

19 N·m {194 kgf·cm, 14 ft·lbf}

3. INSTALL REAR NO. 2 SEAT ASSEMBLY LH

(a) Place the seat onto the lock striker.

(b) Fully lock the seat to the lock striker.

HINT:

  • Confirm that the seat is firmly locked to the lock striker.
  • The rear No. 2 seat leg should be set to the center of the lock striker.

(c) Install the rear No. 2 seat assembly LH and tighten the 4 bolts in the order shown in the illustration.

Torque:

39 N·m {398 kgf·cm, 29 ft·lbf}

(d) Engage the 2 clamps and install the wire harness.

(e) Connect the connector.

4. INSTALL NO. 2 SEAT HINGE COVER

(a) Engage the 6 claws and install the 2 No. 2 seat hinge covers.

(b) Install the 2 screws.

5. INSTALL REAR SEAT LEG SIDE GARNISH SUB-ASSEMBLY LH

(a) Engage the 4 clips and 2 claws, and then install the rear seat leg side garnish sub-assembly LH.

6. INSTALL REAR NO. 2 SEAT LEG SIDE GARNISH SUB-ASSEMBLY

(a) Engage the 9 clips and install the rear No. 2 seat leg side garnish sub-assembly.

7. CHECK REAR NO. 2 POWER SEAT WITH STOWING FUNCTION

2016 - 2020 MY Sienna [12/2015 -        ]; SEAT: REAR POWER SEAT CONTROL SYSTEM: ON-VEHICLE INSPECTION+

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

(a) When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page 2016 - 2020 MY Sienna [12/2015 -        ]; SEAT: REAR POWER SEAT CONTROL SYSTEM: INITIALIZATION ).