Last Modified: 04-05-2023 |
6.11:8.1.0 |
Doc ID: RM100000000VJW4 |
Model Year Start: 2016 |
Model: Sienna |
Prod Date Range: [12/2015 -
] |
Title: SEAT: REAR POWER SEAT CONTROL SYSTEM: Power Source Circuit; 2016 - 2020 MY Sienna [12/2015 - ] |
DESCRIPTION
Power is supplied to the fold seat control ECU through the ECU-IG NO. 2 and FOLD SEAT fuses.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuse for circuits related to this system before performing the following inspection procedure.
PROCEDURE
1.
|
CHECK HARNESS AND CONNECTOR (FOLD CONTROL ECU - BATTERY AND BODY GROUND)
|
(a) Disconnect the b2 and b3 or a2 and a3 fold seat control ECU connectors.
|
|
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
LH Side
Tester Connection
|
Switch Condition
|
Specified Condition
|
b2-3 (IG) - Body ground
|
Engine switch off
|
Below 1 V
|
Engine switch on (IG)
|
11 to 14 V
|
b3-4 (+B) - Body ground
|
Always
|
11 to 14 V
|
RH Side
Tester Connection
|
Switch Condition
|
Specified Condition
|
a2-3 (IG) - Body ground
|
Engine switch off
|
Below 1 V
|
Engine switch on (IG)
|
11 to 14 V
|
a3-4 (+B) - Body ground
|
Always
|
11 to 14 V
|
Text in Illustration
*a
|
Front view of wire harness connector
(to Fold Seat Control ECU)
|
*b
|
LH Side
|
*c
|
RH Side
|
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
LH Side
Tester Connection
|
Condition
|
Specified Condition
|
b3-8 (GND) - Body ground
|
Always
|
Below 1 Ω
|
RH Side
Tester Connection
|
Condition
|
Specified Condition
|
a3-8 (GND) - Body ground
|
Always
|
Below 1 Ω
|
(d) Reconnect the fold seat control ECU connectors.
OK |
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE
(See page
)
|
NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR
|
|