- Front seat outer belt assembly LH
- Harness or connector
- Seat belt control ECU
| Last Modified: 04-05-2023 | 6.11:8.1.0 | Doc ID: RM100000000VJSU |
| Model Year Start: 2016 | Model: Sienna | Prod Date Range: [12/2015 - 11/2017] |
| Title: PRE-COLLISION: PRE-COLLISION SYSTEM: B2007; Open in Seat Belt Motor LH Circuit; 2016 - 2017 MY Sienna [12/2015 - 11/2017] | ||
|
DTC |
B2007 |
Open in Seat Belt Motor LH Circuit |
DESCRIPTION
The seat belt control ECU receives information from the driving support ECU using CAN communication and tightens the seat belt by operating the motor in the front seat outer belt assembly LH.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
B2007 |
Open in the seat belt motor LH circuit continues for 1 second or more. |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
CAUTION:
The pretensioner is built into the front seat outer belt assembly LH. Be sure to follow the correct inspection procedure, as failure to follow the correct procedure (such as inspection of incorrect connectors) may deploy the pretensioner.
PROCEDURE
|
1. |
INSPECT FRONT SEAT OUTER BELT ASSEMBLY LH |
|
(a) Disconnect the K5 front seat outer belt assembly LH connector. |
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
K5-1 - K5-2 |
Always |
Below 20 Ω |
Text in Illustration
|
*1 |
Component without harness connected (Front Seat Outer Belt Assembly LH) |
(c) Reconnect the front seat outer belt assembly LH connector.
| NG |
|
|
|
2. |
CHECK HARNESS AND CONNECTOR (FRONT SEAT OUTER BELT ASSEMBLY LH - SEAT BELT CONTROL ECU) |
(a) Disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(b) Disconnect the K5 front seat outer belt assembly LH connector.
(c) Disconnect the D84 seat belt control ECU connector.
(d) Using a service wire, connect 1 and 2 of the K5 connector on the front seat outer belt assembly LH.
NOTICE:
Do not forcibly insert the service wire into the terminals of the connector.
(e) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
D84-3 (MOL+) - D84-4 (MOL-) |
Always |
Below 20 Ω |
(f) Reconnect the seat outer belt assembly LH and seat belt control ECU connectors.
(g) Connect the cable to the negative (-) battery terminal.
| OK |
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|