- Rear airbag sensor LH malfunction
- Center airbag sensor assembly malfunction
| Last Modified: 04-05-2023 | 6.11:8.1.0 | Doc ID: RM100000000VJQX |
| Model Year Start: 2016 | Model: Sienna | Prod Date Range: [12/2015 - ] |
| Title: SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: B1635/24; Rear Airbag Sensor LH Circuit Malfunction; 2016 - 2020 MY Sienna [12/2015 - ] | ||
|
DTC |
B1635/24 |
Rear Airbag Sensor LH Circuit Malfunction |
DESCRIPTION
The rear airbag sensor LH consists of the safing sensor, the diagnostic circuit, the lateral deceleration sensor, etc.
If the center airbag sensor assembly receives signals from the lateral deceleration sensor, it determines whether the SRS should be activated.
DTC B1635/24 is recorded when a malfunction is detected in the rear airbag sensor LH circuit.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
B1635/24 |
When one of following conditions is met: |
|
WIRING DIAGRAM
PROCEDURE
|
1. |
CHECK REAR AIRBAG SENSOR LH |
(a) Turn the ignition switch off.
(b) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
(c) Interchange the rear airbag sensor RH with LH and connect the connectors to them.
(d) Connect the cable to the negative battery terminal, and wait for at least 2 seconds.
(e) Turn the ignition switch to ON, and wait for at least 60 seconds.
(f) Clear the DTCs stored in the memory (See page
![2016 - 2020 MY Sienna [12/2015 - ]; SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: DTC CHECK / CLEAR](/t3Portal/stylegraphics/info.gif)
).
(g) Turn the ignition switch off.
(h) Turn the ignition switch to ON, and wait for at least 60 seconds.
(i) Check for DTCs (See page
).
Result
|
Result |
Proceed to |
|---|---|
|
DTC B1630/23 and B1635/24 are not output |
A |
|
DTC B1630/23 is output |
B |
|
DTC B1635/24 or is output |
C |
Text in Illustration
|
*1 |
Rear Airbag Sensor RH |
|
*2 |
Side Airbag Sensor LH |
HINT:
DTCs other than B1630/23 and B1635/24 may be output at this time, but they are not related to this check.
(j) Turn the ignition switch off.
(k) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
(l) Return the rear airbag sensor RH and LH to their original positions and connect the connectors to them.
| C |
|
| A |
|
| B |
|
|
|