Last Modified: 04-05-2023 6.11:8.1.0 Doc ID: RM100000000VJQW
Model Year Start: 2016 Model: Sienna Prod Date Range: [12/2015 -           ]
Title: SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: B1630/23; Rear Airbag Sensor RH Circuit Malfunction; 2016 - 2020 MY Sienna [12/2015 -        ]

DTC

B1630/23

Rear Airbag Sensor RH Circuit Malfunction

DESCRIPTION

The rear airbag sensor RH consists of the safing sensor, the diagnostic circuit, the lateral deceleration sensor, etc.

If the center airbag sensor assembly receives signals from the lateral deceleration sensor, it determines whether the SRS should be activated.

DTC B1630/23 is recorded when a malfunction is detected in the rear airbag sensor RH circuit.

DTC No.

DTC Detection Condition

Trouble Area

B1630/23

When one of following conditions is met:

  • Rear airbag sensor RH malfunction
  • Center airbag sensor assembly malfunction
  • Rear airbag sensor RH
  • Center airbag sensor assembly

WIRING DIAGRAM

PROCEDURE

1.

CHECK REAR AIRBAG SENSOR RH

(a) Turn the ignition switch off.

(b) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

(c) Interchange the rear airbag sensor RH with LH and connect the connectors to them.

(d) Connect the cable to the negative battery terminal, and wait for at least 2 seconds.

(e) Turn the ignition switch to ON, and wait for at least 60 seconds.

(f) Clear the DTCs stored in the memory (See page 2016 - 2020 MY Sienna [12/2015 -        ]; SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: DTC CHECK / CLEAR ).

(g) Turn the ignition switch off.

(h) Turn the ignition switch to ON, and wait for at least 60 seconds.

(i) Check for DTCs (See page 2016 - 2020 MY Sienna [12/2015 -        ]; SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: DTC CHECK / CLEAR ).

Result

Result

Proceed to

DTC B1630/23 and B1635/24 are not output

A

DTC B1635/24 is output

B

DTC B1630/23 is output

C

Text in Illustration

*1

Rear Airbag Sensor LH

*2

Side Airbag Sensor RH

HINT:

DTCs other than B1630/23 and B1635/24 may be output at this time, but they are not related to this check.

(j) Turn the ignition switch off.

(k) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

(l) Return the rear airbag sensor RH and LH to their original positions and connect the connectors to them.

C

REPLACE CENTER AIRBAG SENSOR ASSEMBLY

A

USE SIMULATION METHOD TO CHECK

B

REPLACE REAR AIRBAG SENSOR RH