SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION; 2016 - 2020 MY Sienna [12/2015

Last Modified: 04-05-2023	6.11:8.1.0	Doc ID: RM100000000VJPJ
Model Year Start: 2016	Model: Sienna	Prod Date Range: [12/2015 - ]
Title: SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION; 2016 - 2020 MY Sienna [12/2015 - ]

INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page ).

PROCEDURE

1. INSTALL AIRBAG SENSOR BRACKET

(a) Install the airbag sensor bracket with the 4 bolts.

Torque:

17.5 N·m {178 kgf·cm, 13 ft·lbf}

2. INSTALL AIRBAG SENSOR ASSEMBLY

(a) Check that the ignition switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Check that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

Torque:

17.5 N·m {178 kgf·cm, 13 ft·lbf}

NOTICE:

Do not use a airbag sensor assembly that has been dropped.
Do not subject the airbag sensor assembly to any impact or force.
Check that the carpet does not interfere with the installation plane.

(d) Check that there is no looseness by shaking the airbag sensor assembly.

(e) Connect the connector holder to lock the lever.

Text in Illustration

*a	Lever
*b	Drip-proof Sheet

NOTICE:

Check that the lever is locked.

(f) Check that the drip-proof sheet has not been removed and does not cut into the connectors.

3. INSTALL REAR NO. 3 AIR DUCT

(a) Engage 6 claws to install the rear No. 3 air duct.

4. INSTALL REAR NO. 1 AIR DUCT

(a) Engage 6 claws to install the rear No. 1 air duct.

5. INSTALL INSTRUMENT CLUSTER FINISH LOWER CENTER PANEL SUB-ASSEMBLY

6. INSTALL INSTRUMENT PANEL FINISH PANEL END RH

7. INSTALL INSTRUMENT PANEL FINISH PANEL END LH

8. INSTALL INSTRUMENT LOWER CENTER COVER (w/ Console Box)

9. INSTALL INSTRUMENT LOWER CENTER COVER (w/o Console Box)

10. INSTALL CONSOLE BOX ASSEMBLY (for Slide Type)

(See page )

11. INSTALL CONSOLE BOX ASSEMBLY (for Fixed Type)

(See page )

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

Torque:

5.4 N·m {55 kgf·cm, 48 in·lbf}

13. INSPECT SRS WARNING LIGHT

(See page )