Last Modified: 04-05-2023 |
6.11:8.1.0 |
Doc ID: RM100000000VJP0 |
Model Year Start: 2016 |
Model: Sienna |
Prod Date Range: [12/2015 -
] |
Title: SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY: INSTALLATION; 2016 - 2020 MY Sienna [12/2015 - ] |
INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page
).
PROCEDURE
1. INSTALL KNEE AIRBAG ASSEMBLY
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Connect the airbag connector.
Text in Illustration
NOTICE:
Securely lock the locking button.
|
|
(d) Connect the DLC3.
(e) Install the knee airbag assembly with the 4 bolts.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
2. INSTALL NO. 1 INSTRUMENT PANEL LOWER FINISH PANEL
3. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
4. INSTALL COWL SIDE TRIM BOARD LH
5. INSTALL DOOR SCUFF PLATE ASSEMBLY LH
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page
).
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
7. INSPECT SRS WARNING LIGHT
(See page
)
|