Last Modified: 04-05-2023 |
6.11:8.1.0 |
Doc ID: RM100000000VJOY |
Model Year Start: 2016 |
Model: Sienna |
Prod Date Range: [12/2015 -
] |
Title: SUPPLEMENTAL RESTRAINT SYSTEMS: SPIRAL CABLE: REMOVAL; 2016 - 2020 MY Sienna [12/2015 - ] |
REMOVAL
CAUTION / NOTICE / HINT
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page
).
PROCEDURE
1. POSITION FRONT WHEELS FACING STRAIGHT AHEAD
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page
).
3. REMOVE STEERING WHEEL ASSEMBLY
(See page
)
4. REMOVE LOWER STEERING COLUMN COVER
5. REMOVE UPPER STEERING COLUMN COVER
6. REMOVE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY
Text in Illustration
(a) Disconnect the connector.
(b) Slide the slider and disconnect the airbag connector.
(c) Disconnect the steering angle sensor connector.
(d) w/ Steering Heater:
(1) Disconnect the steering heater connector.
|
|
(e) Disengage the 3 claws to remove the spiral with sensor cable sub-assembly.
CAUTION:
-
Do not replace the spiral with sensor cable sub-assembly when the ignition switch is ON and the battery cable is connected.
-
Do not rotate the spiral with sensor cable sub-assembly when the ignition switch is ON and the battery cable is connected.
-
Make sure the steering wheel is installed and centered before rotating the steering angle sensor when performing steering angle sensor operation inspections (inspecting for abnormal noise, diagnosis inspections, etc.).
-
Do not remove the steering angle sensor from the spiral with sensor cable sub-assembly.
-
If there is a malfunction in the steering angle sensor, replace the spiral with sensor cable sub-assembly.
|
|
|