| Last Modified: 04-05-2023 | 6.11:8.1.0 | Doc ID: RM100000000VJEY |
| Model Year Start: 2016 | Model: Sienna | Prod Date Range: [12/2015 - ] |
| Title: NETWORKING: LIN COMMUNICATION SYSTEM: DATA LIST / ACTIVE TEST; 2016 - 2020 MY Sienna [12/2015 - ] | ||
DATA LIST / ACTIVE TEST
1. READ DATA LIST
HINT:
Using the Techstream to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Data List / All Data.
(e) According to the display on the Techstream, read the Data List.
Main Body
|
Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
|---|---|---|---|
|
Communication D-Door Motor |
Connection status between power window regulator motor assembly (for front LH) and main body ECU / OK or STOP |
OK: Connection STOP: No connection |
When there is a malfunction, a DTC is stored. |
|
Communication P-Door Motor |
Connection status between power window regulator motor assembly (for front RH) and main body ECU / OK or STOP |
OK: Connection STOP: No connection |
When there is a malfunction, a DTC is stored. |
|
Communication RR-Door Motor |
Connection status between power window regulator motor assembly (for rear RH) and main body ECU / OK or STOP |
OK: Connection STOP: No connection |
When there is a malfunction, a DTC is stored. |
|
Communication RL-Door Motor |
Connection status between power window regulator motor assembly (for rear LH) and main body ECU / OK or STOP |
OK: Connection STOP: No connection |
When there is a malfunction, a DTC is stored. |
|
Communication Master SW |
Connection status between power window ECU (multiplex network master switch assembly) and main body ECU / OK or STOP |
OK: Connection STOP: No connection |
When there is a malfunction, a DTC is stored. |
|
The Number of DTC |
Number of trouble codes / Min.: 0, Max.: 255 |
Number of DTCs |
- |
Smart Key
|
Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
|---|---|---|---|
|
IG(Lin) |
State of IG signal from LIN communication recognized by steering lock actuator assembly/ON or OFF |
ON: Ignition switch ON OFF: Ignition switch off |
The display is the same as IG2. |
|
|