Last Modified: 04-05-2023 6.11:8.1.0 Doc ID: RM100000000VJB6
Model Year Start: 2016 Model: Sienna Prod Date Range: [12/2015 - 08/2016]
Title: PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM: C1AC1; Master Module Horizontal Axis Misalignment; 2016 MY Sienna [12/2015 - 08/2016]

DTC

C1AC1

Master Module Horizontal Axis Misalignment

DESCRIPTION

This DTC is stored when the angle of the blind spot monitor sensor RH deviates more than the allowable range from the horizontal axis.

HINT:

If a drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor main switch (warning canceling switch assembly) on, the blind spot monitor system may store this DTC by mistake.

DTC No.

DTC Detection Condition

Trouble Area

C1AC1

When the blind spot monitor sensor deviates 5 degrees or more from the horizontal axis when the system is activated

Blind spot monitor sensor RH

CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch (warning canceling switch assembly) is on.

PROCEDURE

1.

CHECK INSTALLATION CONDITION

(a) Check the installation condition of the blind spot monitor sensor RH (See page 2016 MY Sienna [12/2015 - 08/2016]; PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM: OPERATION CHECK ).

HINT:

Take the appropriate action in accordance with the result.

NEXT

2.

PERFORM BEAM AXIS CONFIRMATION

(a) Install the rear bumper (See page 2016 - 2020 MY Sienna [12/2015 -        ]; EXTERIOR PANELS / TRIM: REAR BUMPER: INSTALLATION ).

(b) Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream (See page 2016 MY Sienna [12/2015 - 08/2016]; PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM: OPERATION CHECK ).

OK

END

NG

REPLACE BLIND SPOT MONITOR SENSOR RH