Last Modified: 04-05-2023 6.11:8.1.0 Doc ID: RM100000000VJB3
Model Year Start: 2016 Model: Sienna Prod Date Range: [12/2015 -           ]
Title: PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM: C1ABC; Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete; 2016 - 2020 MY Sienna [12/2015 -        ]

DTC

C1ABC

Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete

DESCRIPTION

This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH.

HINT:

This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.

DTC No.

DTC Detection Condition

Trouble Area

C1ABC

A beam axis inspection has not been performed.

Blind spot monitor sensor LH

PROCEDURE

1.

PROCEED TO TEST MODE (BLIND SPOT MONITOR BEAM AXIS INSPECTION)

(a) Change the blind spot monitor sensor LH to Test Mode using the Techstream.

HINT:

Refer to Blind Spot Monitor Beam Axis Inspection (See page 2016 MY Sienna [12/2015 - 08/2016]; PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM: OPERATION CHECK 2017 MY Sienna [08/2016 - 11/2017]; PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM: OPERATION CHECK 2018 - 2020 MY Sienna [11/2017 -        ]; PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM: OPERATION CHECK ).

NEXT

END