Last Modified: 04-05-2023 6.11:8.1.0 Doc ID: RM100000000VJB2
Model Year Start: 2016 Model: Sienna Prod Date Range: [12/2015 -           ]
Title: PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM: C1ABB; Blind Spot Monitor Master Module Beam Axis Inspection Incomplete; 2016 - 2020 MY Sienna [12/2015 -        ]

DTC

C1ABB

Blind Spot Monitor Master Module Beam Axis Inspection Incomplete

DESCRIPTION

This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH.

HINT:

This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.

DTC No.

DTC Detection Condition

Trouble Area

C1ABB

A beam axis inspection has not been performed.

Blind spot monitor sensor RH

PROCEDURE

1.

PROCEED TO TEST MODE (BLIND SPOT MONITOR BEAM AXIS INSPECTION)

(a) Change the blind spot monitor sensor RH to Test Mode using the Techstream.

HINT:

Refer to Blind Spot Monitor Beam Axis Inspection (See page 2016 MY Sienna [12/2015 - 08/2016]; PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM: OPERATION CHECK 2017 MY Sienna [08/2016 - 11/2017]; PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM: OPERATION CHECK 2018 - 2020 MY Sienna [11/2017 -        ]; PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM: OPERATION CHECK ).

NEXT

END