- Steering sensor (spiral cable with sensor sub-assembly)
- Parking assist ECU
| Last Modified: 04-05-2023 | 6.11:8.1.0 | Doc ID: RM100000000VJ8G |
| Model Year Start: 2016 | Model: Sienna | Prod Date Range: [12/2015 - 11/2017] |
| Title: PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: C1626; Steering Angle Sensor Failure; 2016 - 2017 MY Sienna [12/2015 - 11/2017] | ||
|
DTC |
C1626 |
Steering Angle Sensor Failure |
DESCRIPTION
This DTC is stored if the parking assist ECU receives a signal via CAN communication from the spiral cable with sensor sub-assembly that indicates an internal malfunction.
|
DTC Code |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
C1626 |
A fail flag is transmitted from the steering angle sensor. |
|
CAUTION / NOTICE / HINT
NOTICE:
-
When "System is initializing" is displayed on the navigation receiver assembly after the battery terminal has been disconnected, correct the steering angle neutral point (See page
![2016 - 2017 MY Sienna [12/2015 - 11/2017]; PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: INITIALIZATION](/t3Portal/stylegraphics/info.gif)
).
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (See page
).
PROCEDURE
|
1. |
REPLACE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY |
(a) Replace the spiral cable with sensor sub-assembly (See page
).
|
|
2. |
CHECK DTC OUTPUT |
(a) Clear the DTCs (See page
).
(b) Check for DTCs (See page
).
Result
|
Result |
Proceed to |
|---|---|
|
DTC C1626 is output |
A |
|
No DTC is output |
B |
| A |
|
| B |
|
END |
|
|