Last Modified: 04-05-2023 6.11:8.1.0 Doc ID: RM100000000VJ8D
Model Year Start: 2016 Model: Sienna Prod Date Range: [12/2015 - 11/2017]
Title: PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: C1613; ACC Voltage is Low or High; 2016 - 2017 MY Sienna [12/2015 - 11/2017]

DTC

C1613

ACC Voltage is Low or High

DESCRIPTION

This DTC is stored if the parking assist ECU judges as a result of its self check that the voltage received by terminal ACC is not normal.

DTC Code

DTC Detection Condition

Trouble Area

C1613
  • ACC voltage is low
  • ACC voltage is high
  • Harness or connector
  • Parking assist ECU

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

  • When "System is initializing" is displayed on the navigation receiver assembly after the battery terminal has been disconnected, correct the steering angle neutral point (See page 2016 - 2017 MY Sienna [12/2015 - 11/2017]; PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: INITIALIZATION ).
  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (See page 2016 - 2017 MY Sienna [12/2015 - 11/2017]; PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: CALIBRATION ).
  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1.

CHECK DTC OUTPUT

(a) Clear the DTCs (See page 2016 - 2017 MY Sienna [12/2015 - 11/2017]; PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: DTC CHECK / CLEAR ).

(b) Check for DTCs (See page 2016 - 2017 MY Sienna [12/2015 - 11/2017]; PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: DTC CHECK / CLEAR ).

Result

Result

Proceed to

DTC C1613 is output

A

No DTC is output

B

HINT:

If the parking assist ECU cannot read the stored information when it is activated, allowing the ECU to store the information again may return the system to normal.

B

USE SIMULATION METHOD TO CHECK

(See page 2016 MY Sienna [12/2015 - 08/2016]; INTRODUCTION: HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS: HOW TO PROCEED WITH TROUBLESHOOTING 2017 MY Sienna [08/2016 - 11/2017]; INTRODUCTION: HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS: HOW TO PROCEED WITH TROUBLESHOOTING )
A

2.

CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU ACC VOLTAGE)

(a) Disconnect the parking assist ECU connector.

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Switch Condition

Specified Condition

D163-9 (ACC) - D163-4 (GND1)

Ignition switch ACC

11 to 14 V

Text in Illustration

*a

Front view of wire harness connector

(to Parking Assist ECU)
OK

REPLACE PARKING ASSIST ECU

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR