NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: Mute Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier; 2016 - 2017 MY Sienna [12/2015 - 11/2017]

Last Modified: 04-05-2023	6.11:8.1.0	Doc ID: RM100000000VJ6W
Model Year Start: 2016	Model: Sienna	Prod Date Range: [12/2015 - 11/2017]
Title: NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: Mute Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier; 2016 - 2017 MY Sienna [12/2015 - 11/2017]

Mute Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier

DESCRIPTION

This circuit sends a signal to the stereo component amplifier assembly to mute noise. Due to this, the noise produced by changing the sound source ceases.

If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.

If there is a short in the circuit, even though the stereo component amplifier assembly is functioning normally, no sound or only an extremely faint sound can be heard.

WIRING DIAGRAM

PROCEDURE

1.	INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY

(a) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Switch Condition

Specified Condition

L5-1 (MUTE) - Body ground

Ignition switch ACC

Audio system playing

→ Audio system changing modes

2.0 V or higher

→ Below 1 V

Text in Illustration

*a	Component with harness connected (Stereo Component Amplifier Assembly)

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

(See page )

NG

2.	CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)

(a) Disconnect the D153 navigation receiver assembly connector.

(b) Disconnect the L5 stereo component amplifier assembly connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
D153-16 (MUT1) - L5-1 (MUTE)	Always	Below 1 Ω
D153-16 (MUT1) - Body ground	Always	10 kΩ or higher

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

3.	INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY

(a) Disconnect the navigation receiver assembly connector.

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Switch Condition

Specified Condition

D153-16 (MUT1) - Body ground

Ignition switch ACC

Audio system playing

2.0 V or higher

Text in Illustration

*a	Front view of wire harness connector (to Navigation Receiver Assembly)

OK

REPLACE NAVIGATION RECEIVER ASSEMBLY

NG

REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY