NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: Noise Occurs; 2016 - 2020 MY Sienna [12/2015

Last Modified: 04-05-2023	6.11:8.1.0	Doc ID: RM100000000VJ5Y
Model Year Start: 2016	Model: Sienna	Prod Date Range: [12/2015 - ]
Title: NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: Noise Occurs; 2016 - 2020 MY Sienna [12/2015 - ]

Noise Occurs

PROCEDURE

1.	CHECK NOISE CONDITION

(a) Check from which direction the noise comes (front left or right, or rear left or right).

OK:

The location of the noise source can be determined.

GO TO STEP 3

2.	CHECK SPEAKERS

(a) Check the installation condition of the speaker units that are located near the noise source and that there are no cracks, scratches, deformation or other failures.

Result

Result	Proceed to
No malfunction is found	A
A speaker is installed incorrectly	B
Foreign matter is in a speaker	C
A speaker cone paper is broken	D

REINSTALL SPEAKER

REMOVE FOREIGN MATTER

REPLACE SPEAKER

3.	CHECK NOISE CONDITIONS

(a) Check the noise condition.

HINT:

The radio has a noise prevention function to reduce noise when listening to the radio. If a loud noise occurs, check whether the ground at the antenna mounting base and the noise prevention unit are installed and wired correctly.

Condition under which Noise Occurs	Noise Source
Noise increases when the accelerator pedal is depressed, but stops when the engine is stopped	Generator
Noise occurs during A/C or heater operation	Blower motor
Noise occurs when the horn switch is pressed and released or when pressed and held	Horn
Noise occurs synchronously with the turn signal blinking pattern	Flasher
Noise occurs during window washer operation	Washer
Noise occurs during wiper operation	Wiper
Noise occurs when the brake pedal is depressed	Stop light switch
Others	Static electricity

HINT:

In the left column of the table, find the situation that matches the customer's complaint. Then, in the right column, find the part that is causing the noise. Check the respective noise filter.
To save time and avoid a misdiagnosis, first make sure that the noise is not coming from outside the vehicle.
Troubleshoot noises in descending order of loudness.
Setting the radio to a frequency where no signal is received may make recognition of the noise problem easier.

Result

Result	Proceed to
The noise source cannot be determined	A
The noise source can be determined	B

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

(See page )

REPAIR OR REPLACE NOISE SOURCE