| Last Modified: 04-05-2023 | 6.11:8.1.0 | Doc ID: RM100000000VJ04 |
| Model Year Start: 2016 | Model: Sienna | Prod Date Range: [12/2015 - ] |
| Title: STEERING COLUMN: STEERING WHEEL: INSTALLATION; 2016 - 2020 MY Sienna [12/2015 - ] | ||
INSTALLATION
PROCEDURE
1. INSTALL STEERING WHEEL HEATER CONTROL ASSEMBLY (w/ Steering Heater)
![2016 - 2020 MY Sienna [12/2015 - ]; STEERING COLUMN: STEERING HEATER SWITCH: INSTALLATION+](/t3Portal/stylegraphics/info.gif)
2. INSTALL STEERING PAD SWITCH ASSEMBLY
3. INSTALL CRUISE CONTROL SWITCH WIRE
4. INSTALL CRUISE CONTROL MAIN SWITCH
5. ALIGN FRONT WHEELS TO FACING STRAIGHT AHEAD
6. ADJUST SPIRAL CABLE
7. INSTALL STEERING WHEEL ASSEMBLY
(a) When using a new spiral cable with sensor sub-assembly, brake off and remove the lock pin.
|
(b) Align the matchmarks on the steering wheel assembly and steering main shaft. Text in Illustration
|
|
(c) Install the steering wheel assembly set nut.
Torque:
50 N·m {510 kgf·cm, 37 ft·lbf}
(d) Connect the connectors to the spiral cable sub-assembly.
8. INSTALL STEERING PAD
9. INSTALL LOWER NO. 2 STEERING WHEEL COVER
10. INSTALL LOWER NO. 3 STEERING WHEEL COVER
11. INSPECT STEERING WHEEL CENTER POINT
12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
NOTICE:
- Connect the cable to the negative (-) battery terminal with the front wheels facing straight ahead.
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page
).
13. INSPECT STEERING PAD
14. INSPECT SRS WARNING LIGHT
(See page
)
|
|