| Last Modified: 04-05-2023 | 6.11:8.1.0 | Doc ID: RM100000000VIYT |
| Model Year Start: 2016 | Model: Sienna | Prod Date Range: [12/2015 - ] |
| Title: PARKING BRAKE: PARKING BRAKE PEDAL: REMOVAL; 2016 - 2020 MY Sienna [12/2015 - ] | ||
REMOVAL
PROCEDURE
1. REMOVE SEAT RAIL
(See page
![2016 - 2020 MY Sienna [12/2015 - ]; SEAT: SEAT RAIL: REMOVAL](/t3Portal/stylegraphics/info.gif)
)
2. REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)
(See page
)
3. REMOVE FRONT SEAT ASSEMBLY (for Power Seat)
(See page
)
4. REMOVE CONSOLE BOX ASSEMBLY (for Slide Type)
(See page
)
5. REMOVE CONSOLE BOX ASSEMBLY (for Fixed Type)
(See page
)
6. REMOVE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
(See page
)
7. REMOVE 4WD ECU ASSEMBLY (for AWD)
8. REMOVE BOX BOTTOM MAT
9. REMOVE INSTRUMENT PANEL FINISH PANEL END RH
10. REMOVE INSTRUMENT PANEL FINISH PANEL END LH
11. REMOVE INSTRUMENT LOWER CENTER COVER (w/o Console Box)
12. REMOVE INSTRUMENT LOWER CENTER COVER (w/ Console Box)
13. REMOVE INSTRUMENT CLUSTER FINISH LOWER CENTER PANEL SUB-ASSEMBLY
14. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
15. SEPARATE NO. 1 SLIDE DOOR WEATHERSTRIP LH
16. REMOVE CENTER PILLAR LOWER GARNISH LH
17. LOOSEN ADJUSTING NUT
|
(a) Loosen the lock nut and adjusting nut. Text in Illustration
|
|
18. SEPARATE NO. 2 PARKING BRAKE CABLE ASSEMBLY
|
(a) Separate the No. 2 parking brake cable assembly from the parking brake equalizer. |
|
19. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY
|
(a) Separate the No. 3 parking brake cable assembly from the parking brake equalizer. |
|
20. REMOVE PARKING BRAKE EQUALIZER
|
(a) Slide the rubber boot as shown in the illustration. |
|
|
(b) Remove the parking brake equalizer from the No. 1 parking brake cable assembly as shown in the illustration. |
|
21. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY
(a) Disengage the clips and peel back the floor carpet.
HINT:
Peel back the floor carpet enough to allow separation and connection of the No. 1 parking brake cable assembly.
|
(b) Remove the 3 bolts and 2 nuts and remove the center body pillar sub-assembly LH. |
|
(c) Remove the 8 bolts and separate the No. 1 parking brake cable assembly from the body.
|
(d) Pull out the No. 1 parking brake cable assembly toward the cabin. |
|
|
(e) Disconnect the parking brake switch connector. |
|
|
(f) Separate the clip and hood lock control cable from the parking brake control pedal assembly. |
|
|
(g) Remove the 3 nuts and parking brake control pedal assembly. |
|
|
|